Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Toro 22155TE
Summary of Contents for Toro 22155TE
- Page 1 Form No. 3362-704 Rev A 21in Commercial Lawn Mower Model No. 22155TE—Serial No. 310000001 and Up Model No. 22156TE—Serial No. 310000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Setup................7 additional information, contact an Authorized Service 1 Installing the Handle.......... 7 Dealer or Toro Customer Service and have the model 2 Filling the Engine with Oil ......... 9 and serial numbers of your product ready. Figure 1 3 Install the Mulch Plug or Grass Bag ....9 identifies the location of the model and serial numbers Product Overview ............ -
Page 3: Safety
Removing the Lawn Mower from Storage.... 24 comply with these safety instructions. Troubleshooting............25 Toro designed and tested this mower for reasonably safe service; however, failure to comply with the following instructions may result in personal injury. To ensure maximum safety, best performance, and... -
Page 4: Maintenance And Storage
• If gasoline is spilled, do not attempt to start the – Do not mow excessively steep slopes. engine but move the mower away from the area of – Exercise extreme caution when on slopes. spillage and avoid creating any source of ignition –... -
Page 5: Sound Pressure
Uncertainty Value (K) of 2.3 • To ensure the best performance and safety, . The measured values were determined according purchase only genuine Toro replacement parts to the procedures outlined in EN 836. and accessories. Do not use will fit parts and accessories;... - Page 6 114-2820 1. Warning—read the 4. Cutting/dismemberment Operator’s Manual. hazard of hand or foot, mower blade—stay away 110-9457 from moving parts. 2. Thrown object 5. Cutting/dismemberment 1. Engine switch Off 3. Unlocked hazard—keep bystanders hazard of hand or foot, 2. Engine switch On 4.
-
Page 7: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Bolt (1/2 x 1-1/2 inches) Curved washer Install the handle. Spacer Locknut (1/2 inch) SAE 30 detergent oil with an API service 20 oz. - Page 8 Figure 5 Figure 7 1. Higher handle position 2. Lower handle position 1. Self-propel drive cable 3. Attach cable end here 2. Insert cable jacket end here Note: Torque all bolts to 120 in-lb (13.6 N·m). 3. Route the blade brake cable around the outside of 5.
-
Page 9: Filling The Engine With Oil
D. Tighten the set screw (Figure 11). E. Install the air cleaner cover. 8. Install the back cover with the two screws you removed in step 1. Filling the Engine with Oil Parts needed for this procedure: 20 oz. SAE 30 detergent oil with an API service classification (0.55 l) of SH, SJ, SL, or higher (not supplied with the mower). -
Page 10: Install The Mulch Plug Or Grass Bag
Install the Mulch Plug or Grass No Parts Required Procedure You must correctly install the mulch plug (for mulching or side-discharging) or grass bag (for bagging) or the engine will not start. The mower has a safety switch, located at the bottom of a channel on the top, right rear of the mower, that prevents the mower from operating without a mulch plug or grass bag. -
Page 11: Product Overview
2. Fast 4. Stop 1. Grass bag 3. Mulch plug (installed) 2. Side discharge chute Specifications Model Weight* Length Width Height 22155TE 87 lb 61 in 23 in 41 in (39 kg) (155 cm) (58 cm) (104 cm) 22156TE 91 lb... -
Page 12: Operation
Filling the Fuel Tank with Operation Gasoline Note: Determine the left and right sides of the machine from the normal operating position. Checking the Engine Oil Level Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you Service Interval: Before each use or daily and others. - Page 13 Figure 21 1. Top of mulch plug lever in switch channel Figure 23 3. Move the choke/throttle lever to the Choke position (Figure 18). 4. Hold the blade control bar against the handle and pull the recoil starter once or twice (Figure 24). Note: Pull the recoil start handle lightly until you feel resistance, then pull it briskly.
-
Page 14: Stopping The Engine
Stopping the Engine Service Interval: Before each use or daily To stop the engine, release the blade control bar (Figure 25). Important: When you release the blade control bar, both the engine and blade should stop within 3 seconds. If they do not stop properly, stop using your mower immediately and contact an Authorized Service Dealer. -
Page 15: Mulching The Clippings
(refer to Check the grass bag frequently. If it is Removing the Side Discharge Chute) before mulching damaged, install a new Toro replacement bag. the clippings. Important: The mower has a safety switch that... -
Page 16: Installing The Grass Bag
Installing the Grass Bag 1. Remove the mulch plug (Figure 29). Figure 30 2. Insert the mulch plug (Figure 31). Figure 29 2. Insert the grass bag handle into the grooves at the top of the mower. Important: The mower has a safety switch that prevents you from starting the mower unless you first install the grass bag securely on the mower. -
Page 17: Side-Discharging The Clippings
Side-discharging the Clippings Use the side discharge for cutting very tall grass. If the bag is on the mower, remove it and insert the mulch plug (refer to Removing the Grass Bag) before side-discharging the clippings. Important: The mower has a safety switch that prevents you from starting the mower unless you first install the mulch plug securely on the mower (refer to Mulching the Clippings). -
Page 18: Operating Tips
Periodically file down nicks on the blade. the clippings over the lawn for even fertilization. • Replace the blade when necessary with an original Toro replacement blade. If the finished lawn appearance is unsatisfactory, try one or more of the following: •... -
Page 19: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. • Ensure that the engine stops within 3 seconds after releasing the blade control bar. Before each use or daily •... -
Page 20: Engine Maintenance
Engine Maintenance 5. If the air filter is dirty, tap it on a hard surface several times or blow compressed air less than 30 psi (207 kPa) through the side of the filter that faces the Servicing the Air Cleaner engine. -
Page 21: Servicing The Spark Plug
Figure 42 Figure 41 1. Center electrode insulator 2. Side electrode 3. Air gap (not to scale) 4. Slowly pour oil into the oil fill tube, periodically checking the level with the dipstick, until the dipstick indicates that the engine is full as illustrated in 6. -
Page 22: Drive System Maintenance
Blade Maintenance Drive System Maintenance Maintaining the Cutting Blade Adjusting the Self-propel Drive Service Interval: Yearly Examine the blade whenever you run out of gasoline. If Model 22156TE only the blade is damaged or cracked, replace it immediately. If the mower does not self-propel or it creeps forward If the blade edge is dull or nicked, have it sharpened or when the self-propel drive bar is more than 2-1/4 inches replace it. -
Page 23: Cleaning
Cleaning Cleaning the Mower Housing Service Interval: Before each use or daily The mower may dislodge material from under the mower housing. • Wear eye protection. • Stay in the operating position (behind the handle). • Do not allow bystanders in the area. 1. -
Page 24: General Information
General Information Storage 1. Clean the mower housing. Refer to Cleaning under To prepare the mower for off-season storage, perform the Mower Housing. the recommended maintenance procedures. Refer to 2. Clean any dirt and chaff from the cylinder, cylinder Maintenance. head fins, and blower housing. -
Page 25: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action Engine does not start 1. The fuel tank is empty or the fuel 1. Drain and/or fill the fuel tank with system contains stale fuel. fresh gasoline. If the problem persists, contact an Authorized Service Dealer. 2. - Page 26 Problem Possible Cause Corrective Action Mower does not self-propel 1. The self-propel drive cable is out of 1. Adjust the self-propel drive cable. adjustment or is damaged. Replace the cable if necessary. 2. There is debris under the belt cover. 2.
- Page 27 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev D...
- Page 28 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.