Table of Contents
Advertisement
Quick Links
50cm Mulching/Rear Bagging Lawn Mower
Model No. 29641—Serial No. 290000001 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Figure 1
1. Model and serial number plate
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
Figure 2
1. Safety alert symbol
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
This manual uses two words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Do not tamper with the engine controls or alter the
governor speed; doing so may create an unsafe condition
resulting in personal injury.
Safety
Improperly using or maintaining this mower can
result in injury. To reduce the potential for injury,
comply with these safety instructions.
Toro designed and tested this mower for reasonably safe
service; however, failure to comply with the following
instructions may result in personal injury.
To ensure maximum safety, best performance, and
to gain knowledge of the product, it is essential
that you and any other operator of the mower read
and understand the contents of this manual before
the engine is ever started. Pay particular attention
to the safety alert symbol (Figure 2) which means
Caution, Warning, or Danger—"personal safety
instruction." Read and understand the instruction
because it has to do with safety. Failure to comply
with the instruction may result in personal injury.
General Lawn Mower Safety
The following instructions have been adapted from EN
836.
This cutting machine is capable of amputating hands
and feet and throwing objects. Failure to observe the
following safety instructions could result in serious
injury or death.
Register at www.Toro.com.
Form No. 3362-340 Rev A
Operator's Manual
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Toro 29641
Summary of Contents for Toro 29641
-
Page 1: General Lawn Mower Safety
Authorized Service Do not tamper with the engine controls or alter the Dealer or Toro Customer Service and have the model governor speed; doing so may create an unsafe condition and serial numbers of your product ready. Figure 1 resulting in personal injury. - Page 2 Training absolutely necessary and lift only the part, which is away from the operator. • Read the instructions carefully. Be familiar with the controls and the proper use of the equipment. • Start the engine or switch on the motor carefully according to instructions and with feet well away •...
-
Page 3: Sound Pressure
• To ensure the best performance and safety, purchase only genuine Toro replacement parts and accessories. Do not use will fit parts and accessories; they may cause a safety hazard. -
Page 4: Safety And Instructional Decals
Safety and Instructional Setup Decals Important: Remove and discard the protective Important: Safety and instruction decals are plastic sheet that covers the engine. located near areas of potential danger. Replace damaged decals. 1. Unfolding the Handle Procedure Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. -
Page 5: Filling The Engine With Oil
2. Filling the Engine with Oil Product Overview Procedure Your mower does not come with oil in the engine, but it does come with a bottle of oil. 1. Remove the dipstick (Figure 4). Figure 4 Figure 5 6. Blade control bar 1. -
Page 6: Checking The Engine Oil Level
Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories. Filling the Fuel Tank Gasoline is extremely flammable and explosive. -
Page 7: Using The Self-Propel Drive
Note: To raise the mower, move all the cutting height levers forward; to lower the mower, move the all the cutting height levers rearward (Figure 9). Figure 11 Note: If the mower does not start after several attempts, contact an Authorized Service Dealer. Using the Self-propel Drive To operate the self-propel drive, squeeze the self-propel drive bar (Figure 12) toward the handle and hold it. -
Page 8: Mulching The Clippings
Use the rear-discharge deflector for cutting very tall Check the grass bag frequently. If it is grass. damaged, install a new Toro replacement bag. Installing the Rear-Discharge Deflector 1. If the bag is on the mower, remove it. 2. Lift up the rear deflector and hold it (Figure 15). -
Page 9: Operating Tips
• Slow down your mowing speed if the mower does cutting season begins. not cut the leaves finely enough. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. -
Page 10: Recommended Maintenance Schedule(S)
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •... -
Page 11: Changing The Engine Oil
Figure 20 3. Install the cover. Figure 22 Changing the Engine Oil 4. Slowly pour oil into the oil fill tube until the oil level reaches the Full line on the dipstick (Figure 21). Do Service Interval: After the first 5 hours not overfill. -
Page 12: Adjusting The Self-Propel Drive Cable
Adjusting the Self-propel Drive Cable Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive cable. 1. Loosen the cable support nut (Figure 24). Figure 23 Important: Position the curved ends of the blade to point toward the mower housing. -
Page 13: Cleaning The Mower
Cleaning the Mower Storage Service Interval: Before each use or daily Store the mower in a cool, clean, dry place. Preparing the Mower for The mower may dislodge material from under Storage the mower housing. • Wear eye protection. • Stay in the operating position (behind the Gasoline vapors can explode. -
Page 14: Folding The Handle
Folding the Handle Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 1. - Page 15 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev D...
- Page 16 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.