Brother DCP-J525W Basic User's Manual page 52
Hide thumbs
Also See for DCP-J525W:
- Service manual (378 pages) ,
- Basic user's manual (100 pages) ,
- Quick setup manual (32 pages)
Table of Contents
Advertisement
Error Message
Cannot Detect
Cannot Print
Replace Ink
Cover is Open
Data Remaining
Document Jam
(DCP-J725DW)
High Temperature
Hub is Unusable.
(DCP-J725DW)
44
Downloaded from ManualsPrinter.com Manuals
Cause
You installed a new ink cartridge too
quickly and the machine did not detect
it.
If you are using non Brother Original
ink the machine may not detect the ink
cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges have
reached the end of their life. The
machine will stop all print operations.
The scanner cover is not completely
closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The document was not inserted or fed
correctly, or the document scanned
from the ADF was too long.
The print head is too warm.
A Hub or USB Flash memory drive
with Hub has been connected to the
USB direct interface.
Action
Take out the new ink cartridge and
re-install it slowly until it clicks.
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact your
Brother dealer.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges
uu page 37.)
Replace the ink cartridges. (See
Replacing the ink cartridges
uu page 37.)
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover
until it clicks.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
(See Using the ADF (DCP-J725DW
only) uu page 24.)
(See Document jam (DCP-J725DW)
uu page 49.)
Allow the machine to cool down.
Hubs, including USB Flash memory
drives that have a hub built-in, are not
supported. Unplug the device from the
USB direct interface.
Advertisement
Table of Contents
Troubleshooting
