How To Set A New Default - Brother MFC-J6910DW Advanced User's Manual
Hide thumbs
Also See for MFC-J6910DW:
- User manual (271 pages) ,
- Basic user's manual (156 pages) ,
- Advanced user's manual (81 pages)
Table of Contents
Advertisement
Chapter 8
d
Press to Media.
e
Press d or c to display Auto Crop.
f
Press Auto Crop.
g
Press On.
h
If you do not want to change additional
settings, press Black Start or
Color Start to start scanning.
i
The number of the scanned documents
appears on the LCD.
Press OK.
j
Press d or c to preview each document
data.
k
Press Save All to save the data.
Note
• Auto Crop is available for paper with
right angles of 90 degrees at all four
corners. If one of the angles is not square,
Auto Crop cannot detect the document.
• If your document is too long or wide, this
setting does not work properly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
0.4 in. (10 mm) apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use the
Auto Crop.
• The Auto Crop feature is available for up
to a maximum of 16 documents
depending on the size of your documents.
64
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
PHOTO CAPTURE is blinking to avoid
damaging the card, USB Flash memory
drive or the data stored on them.
How to set a new default
You can save the Scan to Media settings
(Quality, File Type,
Glass Scan Size and Auto Crop) you
use most often by setting them as the default
settings. These settings will stay until you
change them again.
a
Press
(SCAN).
b
Press to Media.
c
Press d or c to display
Set New Default.
d
Press Set New Default.
e
Press Yes to confirm.
f
Press Stop/Exit.
8
Advertisement
Table of Contents
