Test Operation (Operating The Treadle) - Brother S-7220B Basic Operation Manual
Single needle direct drive needle feed lock stitcher with thread trimmer
Hide thumbs
Also See for S-7220B:
- Instruction manual (74 pages) ,
- Manual de instrucciones (74 pages) ,
- Parts list (1 page)
Table of Contents
Advertisement
3-5. Test operation (Operating the treadle)
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
3648M
CAUTION
1. Turning on the power
2114M
<Models with operation panel>
Press the ON power switch (1).
The power indicators (2) and (3) will illuminate.
NOTE: When turning the power switch on for the first
time
The treadle and the operation panel will not operate for
approximately four seconds after the power switch is
turned on.
After approximately 4 seconds, "iniT rPM" (speed
initialization) or "iniT ALL" (full initialization) will be
displayed on the operation panel. After "iniT rPM" or "iniT
ALL" is displayed, the treadle can be operated. (The
operation panel will change to the stitch number display.)
This message will not appear the second and subsequent
times that the power switch is turned on.
3730M
<Models without operation panel>
Press the ON power switch (1).
The power indicators (3) and (4) will illuminate.
NOTE: When turning the power switch on for the first
time
The treadle and control box panel cannot be operated for
approximately 4 seconds after the power switch has been
turned on.
After approximately 4 seconds, "Ar (All reset)" may
appear in the stitch number display (5).
If this happens, turn the power switch off and then back
on again. After that, normal treadle operation will then be
possible.
3647M
2. Test operation
1. Check that the machine sews at low speed when the
treadle (1) is gently pressed to position (B).
2. Then check that it sews at high speed when the treadle
(1) is gently pressed to position (C).
3. After pressing the treadle (1) forward, check that the
needle is lowered to the top of the needle plate when the
treadle (1) is returned to the neutral position (A). (when
needle down stopping has been set.)
4. If the treadle (1) is pressed to position (D), thread
trimming is carried out and the needle then rises above
the needle plate and stops.
2117M
S-7220B
3. INSTALLATION
12
Advertisement
Table of Contents
