Cotton Stand - Brother S-7220B Basic Operation Manual
Single needle direct drive needle feed lock stitcher with thread trimmer
Hide thumbs
Also See for S-7220B:
- Instruction manual (74 pages) ,
- Manual de instrucciones (74 pages) ,
- Parts list (1 page)
Table of Contents
Advertisement
3. INSTALLATION
7
<Knee lifter adjustment>
1. Turn the machine pulley so that the feed dog is below the
2. Lower the presser foot (5) by using the lifting lever (4).
3726M
3. Loosen the nut (6).
3781M
4. Turn the screw (8) to adjust so that the amount of play in
5. Securely tighten the nut (6).
<Adjusting the height of the presser foot>
The height of the presser foot can be adjusted to a maximum
of 16 mm.
1. Loosen the nut (9).
2. Turn the adjusting screw (10) to adjust so that the presser
3. After adjustment is completed, securely tighten the nut
Within 16 mm
3727M
S-7220B
10. Cotton stand
(1) Cotton stand
NOTE:
Securely tighten the nut (4) so that
the two rubber cushions (2) and the
washer (3) are securely clamped and
so that the cotton stand (1) does not
move.
3636M
11. Knee lifter plate
(1) Knee lifter plate
(2) Bolt
* Loosen the bolt (3) and move the
knee lifter plate (1) to a position
where it is easy to use.
3637M
top of the needle plate.
the knee lifter (7) is approximately 2 mm when the knee
lifter plate (1) is gently pressed.
foot (5) is at the desired position within a distance of 16
mm of the needle plate when the knee lifter plate (1) is
fully pressed.
(9).
Advertisement
Table of Contents
