Safety Information; Install The Router - Cisco ubr924 Installation And Startup
Cable access router
Hide thumbs
Also See for ubr924:
- Troubleshooting tips (74 pages) ,
- Installation manual (112 pages) ,
- Configuration manual (52 pages)
Advertisement
Install the Router and Connect Cables
Lock
Cable F-connector
Ethernet 10BaseT (RJ-45)
The Cisco uBR924 cable access router is DOCSIS-based and interoperates with any DOCSIS-qualified CMTS.
The router uses Cisco IOS Release 12.0(4)XI, 12.0(5)T, or higher software, and supports many advanced routing
features. The router can be configured to support data, voice, or a mixture of data and voice.
Note: The router ships from the Cisco factory with the console port enabled and a software image that
supports data only. Based on your licensing agreement, you can use Cisco Connection Online (CCO) to
download an image or images that support voice and/or other operating modes. Downloading a Cisco IOS
image disables the console port by default and erases all saved configurations.
Safety Information
Note: Before installing equipment, review the Regulatory Compliance and Safety Information for the
Cisco uBR924 Cable Access Router publication and follow all guidelines. Also refer to the Cisco uBR924
Cable Access Router Installation and Configuration Guide for more in-depth instructions.
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment.
Install the Router
Step 1
Place the router on a stable, flat surface close to the CATV drop connection and all devices to be
connected at the subscriber site.
Step 2
Make sure the bottom, sides, and rear of the router are clear and well-ventilated to prevent the unit
from overheating.
Ether net 0
1
2
3
4
Phon e
Line
Cable TV In
X
X
X
X
v1+v 2 v2
Cons ole
Phone (RJ-11)
Line (RJ-11)
Cisc o uBR 924
5V
3A
8V
0.65A
40V
7mA
Rese t
Powe r
Power receptacle
Reset switch
Console (RJ-45)
3
Advertisement
