Table of Contents
Advertisement
Setting SPAN
The setting procedure for SPANNING OF RAID1 and SPANNING OF RAID5 are shown below
SPANNING OF RAID1
1.
Open the configuration creation screen.
Select "Configure" → "New Configuration" from the TOP menu to display the screen shown below. This is
the Channel-1 menu screen where the cursor is put on ID=0 position:
2.
Select ID-0/1 hard disks.
Pressing Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking.
(The cursor automatically moves to Channel-1, ID=1.) In the same way, press Space on Channel-1, ID=1.
(Where "A01-02" is blinking, the cursor moves to Channel-1, ID=2.) After selecting 2 hard disks (Channel-1,
ID=0/Channel-1, ID=1), press Enter to determine the settings. (Display on each hard disk stops blinking.)
4-41
Advertisement
Table of Contents
