Diagrams; Note For Printed Wiring Boards And Schematic Diagrams - Sony XR-CA630X Service Manual
Hide thumbs
Also See for XR-CA630X:
- Operating instructions manual (150 pages) ,
- Service manual (40 pages) ,
- Installation/connections (4 pages)
Table of Contents
Advertisement
XR-CA630X
6-1.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Waveforms
– MAIN Board –
1 IC51 4 (OSCO)
232 ns
2 IC501 qs (OSCOUT)
54.4 ns
14
SECTION 6
DIAGRAMS
5 Vp-p
3.3 Vp-p
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
• C : panel designation.
• A : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
(
) : MW/LW
〈〈
〉〉 : TAPE PLAYBACK
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: MW/LW
E
: TAPE PLAYBACK
L : BUS AUDIO IN
3 IC501 qh (XOUT)
30.8 µ s
– KEY Board –
4 IC901 uf (OSC)
21.6 µ s
5 Vp-p
2.6 Vp-p
Advertisement
Table of Contents
