Making Connections; Enabling The Computer's External Display; Connecting Your Pc Or Macintosh Computer - NEC LT265 User Manual
Portable projector
Hide thumbs
Also See for LT265:
- Network manual (82 pages) ,
- Installation manual (7 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Making Connections
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the
power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after
connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power
management software.
Enabling the computer's external display
Displaying an image on the notebook PC's screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually, the combination of the 'Fn" key along with one of the 12 function keys gets the external display to come on
or off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle through
external display selections.
Connecting Your PC or Macintosh Computer
IBM PC or Compatibles (Desktop type)
or Macintosh (Desktop type)
Connecting your PC or Macintosh computer to your projector will enable you to project your computer's screen image
for an impressive presentation.
To connect to a PC or Macintosh, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied RGB/VGA signal cable to connect your PC or Macintosh to the projector.
3. Connect the supplied power cable. See page 26.
4. Turn on the projector and the computer.
5. If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer
you've connected to the projector.
COMPUTER 1 IN
PC CARD
LAN
USB
R AUDIO IN L
VIDEO IN
S-VIDEO IN PC CONTROL
AC IN
NOTE: For older Macintosh, use
a commercially available pin
adapter (not supplied) to
connect to your Mac's video
port.
PHONE
Audio cable (not supplied)
2. Installation and Connections
AUDIO IN
NOTE: The COMPUTER 1 IN connector
AUDIO OUT
COMPUTER 1 IN
AUDIO IN
COMPUTER 2 IN
MONITOR OUT
supports Plug & Play (DDC2).
COMPUTER 2 IN
RGB/VGA signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer
than the supplied one.
IBM VGA or Compatibles (Notebook
type) or Macintosh (Notebook type)
17
PHONE
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
