Bosch 1200 Series Quick Installation Manual
Hide thumbs
Also See for 1200 Series:
- Quick manual (4 pages) ,
- Installation manual (24 pages) ,
- Instruction manual (48 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch 1200 Series
Summary of Contents for Bosch 1200 Series
- Page 1 1200/1400 Series as standard iSCSI disk array Quick Installation Guide...
- Page 3 Table of Contents | en Table of Contents Introduction Setup Instruction Setting the IP Address Remote Desktop Connection Physical Connection Disabling the VRM Service Standard System Configuration Additional Software and Documentation Bosch Sicherheitssysteme GmbH Quick Installation Guide - | V1 | 2011.02...
-
Page 4: Setup Instruction
The system is pre-installed with the Bosch Video Recording Manager (VRM). Using the system as standard iSCSI disk arrays, you must disable the VRM Service. Setup Instruction All Bosch DLA Series disk arrays are preconfigured with a default IP address and with default iSCSI settings. –... - Page 5 Use this program to configure the disk array’s IP Address. The top level view of Bosch VRM Appliance initial configuration displays an overview of the system’s configuration and settings. Select the link Configure networking to get access to the network configuration.
-
Page 6: Physical Connection
Connect a monitor, mouse and keyboard (not part of the shipment) to the disk array and start up the system. Note: When connecting a PS2 mouse or keyboard device after the system has been booted it will most likely not operate properly. - | V1 | 2011.02 Quick Installation Guide Bosch Sicherheitssysteme GmbH... - Page 7 On first login the desktop default settings are applied. This will take a few seconds and the system will reboot. After system reboot, log on again and the Bosch VRM Appliance initial configuration window will be shown. Use this program to configure the disk array’s IP Address.
-
Page 8: Disabling The Vrm Service
VRM Service can be disabled: Log on to the storage system, then start the Bosch VRM Appliance initial configuration window. The top level view of the Bosch VRM Appliance initial configuration window displays an overview of the system’s configuration and settings. -
Page 9: Standard System Configuration
Standard System Configuration | en Select the link Disable/Enable Bosch VRM Appliance to stop/start the VRM recording service. To restart the service, on the Bosch VRM Appliance initial configuration window, click the enable Bosch VRM Appliance link. Standard System Configuration The system is delivered with the fully configured iSCSI target and preconfigured LUNs. - Page 10 | Additional Software and Documentation 1200/1400 Series as standard iSCSI disk array - | V1 | 2011.02 Quick Installation Guide Bosch Sicherheitssysteme GmbH...
- Page 12 Bosch Sicherheitssysteme GmbH Werner-von-Siemens-Ring 10 85630 Grasbrunn Germany www.boschsecurity.com © Bosch Sicherheitssysteme GmbH, 2011...