Table of Contents
Advertisement
Appendix
Maintenance
Simply wipe the base station and handset with a damp cloth (without solvents) or an
antistatic wipe. Never use a dry cloth. Otherwise there is a risk of static electricity build-
ing up.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drip out of the device, and then dab all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and answers
If any questions occur to you while you are using your device, we are available 24 hours
a day at www.my--siemens.com/customercare. You will find the most frequently
asked questions and answers below.
What has happened if ... Possible cause
... the display is blank?
... the handset fails to respond
to a key press?
... "Base x" flashes in display?
... Base Search flashes in the
display?
... an Internet address appears
in the display?
!
Handset is not switched on.
The batteries are flat.
The keypad protection is acti-
vated.
The handset is outside the base
station range.
The base station is not activated.
The handset is set to Best Base,
but there is no base station acti-
vated or in range.
The automatic registration of
your handset has been inter-
rupted.
Appendix
Possible solution
Hold down the end call key
for about 2 seconds.
Charge or replace the batteries
(page 10).
Hold down the hash key
for about 2 seconds
(page 11).
Move the handset closer to
base station.
Check the mains connector at
the base station (page 8).
Move the handset closer to
base station.
Check the mains connector at
the base station (page 8).
Register your handset manu-
ally (page 82).
a
R
111
Hide quick links:
Advertisement
Table of Contents
