Cleaning The Air Filter Element And Check Hose - Yamaha TW200 Owner's Manual
Hide thumbs
Also See for TW200:
- Service manual (276 pages) ,
- Owner's manual (100 pages) ,
- Service manual (277 pages)
Table of Contents
Advertisement
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kg, 31 ft·lb)
12. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil
filler cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element
removal:
1.0 L (0.9 Imp qt, 1.1 US qt)
With oil filter element removal:
1.1 L (1.0 Imp qt, 1.2 US qt)
Total amount (dry engine):
1.3 L (1.1 Imp qt, 1.4 US qt)
PERIODIC MAINTENANCE AND MINOR REPAIR
cC
8 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives
with the oil or use oils of a
higher grade than "CD". In
addition,
do
not
labeled "ENERGY CONSERV-
ING
II" or higher.
8 Make sure that no foreign
material enters the crankcase.
13. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the
cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
6-14
EC000072
Cleaning the air filter
element and check hose
The air filter element should be
cleaned at the intervals specified in
the periodic maintenance and lubrica-
tion chart. Clean the air filter element
more frequently if you are riding in
unusually wet or dusty areas. In addi-
use
oils
tion, the air filter check hose must be
frequently checked and cleaned if
necessary.
To clean the air filter element
1. Remove panel A. (See page 6-8
for panel removal and installation
procedures.)
EAU03789*
1
2
3
4
5
6
7
8
9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
