Rear-Panel Ports And Leds - Cisco 1750 Router Overview
Hide thumbs
Also See for 1750 Router:
- Installation manual (84 pages) ,
- Hardware installation manual (6 pages) ,
- Datasheet (11 pages)
Table of Contents
Advertisement
Rear-Panel Ports and LEDs
Rear-Panel Ports and LEDs
Figure 2
Rear-Panel Components and LEDs
Kensington-compatible
locking socket
VIC
2FXS
1
SEE MANUAL BEFORE INSTALLATION
SLOT 1 OK
SLOT 0 OK
Slot 1
Slot 0
WIC/VIC
OK LED
OK LED
Table 2
Rear-Panel Connectors
Connector/Slot
Ethernet port
Auxiliary port
Console port
Cisco 1750 Router Hardware Installation Guide
iv
This section describes the router rear-panel ports and LEDs, which are shown in
Figure 2 and described in Table 2 and Table 3.
WIC/VIC
slot 1
Console port
Cisco 1750
SLOT 1
0
SLOT 0
FDX
100
LINK
10/100 ETHERNET
10/100-Mbps
slot 0
Ethernet port
FDX/100/LINK LEDs
Auxiliary port
Label/Color
10/100-Mbps
ETHERNET
(yellow)
AUX
(black)
CONSOLE
(light blue)
VIC
slot 2
SLOT 2
VIC
2FXO
1
SEE MANUAL BEFORE INSTALLATION
THIS SLOT ACCEPTS ONLY VOICE INTERFACE CARDS
CONSOLE
PVDM OK
AUX
PVDM
OK LED
Ground
wire
Description
Router connection to the local Ethernet network. This
port autosenses the speed (10 or 100 Mbps) and duplex
mode (full or half) of the device to which it is connected
and then operates at the same speed and in the same
duplex mode.
Modem connection for remote configuration using
Cisco IOS software.
Terminal or PC connection for local configuration using
Cisco IOS software.
Power switch
0
SLOT 2 OK
+5, +12, -12 VDC
Slot 2
OK LED
Power
socket
78-6169-02
Advertisement
Table of Contents
