2 ] Error Codes Shown In The "Machine Error - Brother FAX560 Service Manual
Facsimile equipment
Hide thumbs
Also See for FAX560:
- Service manual (162 pages) ,
- Owner's manual (83 pages) ,
- Quick setup (1 page)
Table of Contents
Advertisement
[ 2 ] Error codes shown in the "MACHINE ERROR _ _" message
Error Code
(Hex.)
( 81
( 85
( 87
8A
( 8B
( A1
( A2
( A4
( A5
( A6
( A7
( A8
( AB
( AC
( B9
( BE
( BF
( D2
( D3
( D4
( D5
( D6
( D7
( D8
( D9
E6
( E8
F3
( F5
( F6
( FF
Error codes in parentheses do not appear in the "MACHINE ERROR _ _," since those errors are displayed as
messages described in "[ 1 ] Error messages on the LCD."
maintenance mode (Function code 82). If an equipment error occurs during communications, they appear in the
communications error lists.
1
*
These error codes could appear only in the maintenance mode.
2
*
These errors could occur only in machines equipped with an improved type of drive unit.
Cam sensor error in the drive unit. )
Ink ribbon empty. )
Fails to complete the sequence of recording operation. )
Wrong or weak contact of the recording head connectors.
Recording head overheat. )
Control panel ASSY opened. )
Document too long to scan. )
50% or more faulty of white level data. )
Faulty operation of DMA0 during scanning. )
Faulty operation of DMA1 during scanning. )
One-line feeding time-out error. )
One-line scanning time-out error. )
Document feed-in amount measuring error. )
Less than 50% faulty of white level data. )
Light emission intensity error of the LED array. )
Abnormal clamp PWM value )
Light emission intensity error of the LED array at the setting time of initial values. )
Fatal error. The main PCB should be replaced. )
Same as above. )
Same as above. )
The MODEM fails to complete the command transmission sequence. )
No MODEM interrupt for 60 seconds. )
Fatal error. The main PCB should be replaced. )
Same as above. )
Same as above. )
Write error in EEPROM.
Data scanning error during transmission. )
Voice message recording or playing-back not started.
EOL not found in page memory transmission mode. )
PC interface error. )
Fatal error. The main PCB should be replaced. )
Error factor
You can display those error codes in the
VI - 5
2
*
1
*
1
*
1
*
1
*
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
