Table of Contents
Advertisement
2-7 ZOOM Lens (Optional)
[S14 x 7.3B12U]
e
w
RET
W
r
t
!0
1
FOCUS ring
Manual focus ring.
2
ZOOM lever/ring
This is the manual zoom ring equipped with a zoom lever.
To adjust the zoom manually, turn the zoom mode knob
to position "M".
3
IRIS ring
Manual iris ring. To activate the auto iris feature, set the Iris
7
Mode switch
to "A".
4
[VTR] Trigger button
To start/stop shooting.
5
[RET] return video button
The return video signal from the VTR section can be
monitored in the viewfinder only while this button is pushed.
* The playback picture can be viewed in the viewfinder
during this operation.
6
ZOOM servo control lever
To operate the servo zoom feature with this lever, set the
@
ZOOM knob
to "S".
● Pressing the "W" section of this lever increases the angle
of the lens for a wider shooting angle.
● Pressing the "T" section of this lever narrows the lens
angle perspective for telephoto shots.
● Pushing harder changes the speed of the zoom.
2. CONTROLS, INDICATORS AND CONNECTORS
q
M
A
T
y
u i o
!4
!1
!2
!3
7
IRIS mode switch
A : Activates the auto iris feature.
M : Allows manual iris control.
8
Momentary auto iris button
When the IRIS MODE switch
activates the Auto Iris Function while it is held down only.
9
[S] IRIS speed adjusting control
For adjusting the iris operation speed.
MEMO:
If the speed becomes too fast, hunting may occur.
To avoid the phenomena described above, perform
adjustment again.
0
FILTER thread
Protect the lens with a clear filter or UV filter by screwing
the filter onto the thread inside the lens hood from the front.
Other filters can be used for various effects.
CAUTION:
The filter thread section rotates, so pay attention when
mounting a polarizing filter.
!
ZOOM servo connector
Connect an optional zoom servo unit here.
@
ZOOM mode knob
S : Servo zoom mode. Allows operation by the zoom servo
control lever
M : Manual zoom mode. Allows zoom control by the zoom
2
lever/ring
.
#
BACK FOCUS ring/fixing screw
For back focus adjustment only. Secure with the screw knob
after adjustment.
See "Back Focus Adjustment" on page 47.
$
Macro focusing ring (for close-up shooting)
By rotating this ring in the direction of the arrow, close-up
shooting of very small objects becomes possible.
Normal focus adjustment and zooming are not available in
@
the macro mode.
To shoot images in the macro mode, set the focus ring
to the infinite position ( ) and the zoom ring
maximum wide-angle position. To adjust the focus of the
macro image, rotate this ring in the direction of the arrow
until the object is focused.
CAUTION:
● The back-focus knob is located close to the macro ring,
be careful not to mistake the back-focus knob for the
macro ring.
● After the required operation, be sure to return the macro
focusing ring to the normal position.
See "Attaching the Zoom Lens" on page 30.
See "Back Focus Adjustment" on page 47.
7
is at "M", pushing this button
6
.
1
2
to the
E-27
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
