Starting Circuit Cut-Off System Operation - Yamaha TDM900 R Supplementary Service Manual
Hide thumbs
Also See for TDM900 R:
- Owner's manual (110 pages) ,
- Parts catalog (79 pages) ,
- Owner's manual (110 pages)
Table of Contents
Advertisement
ELECTRIC STARTING SYSTEM
EAS00756
STARTING CIRCUIT CUT-OFF SYSTEM
OPERATION
If the engine stop switch is set to "
main switch is set to "ON" (both switches are
closed), the starter motor can only operate if at
least one of the following conditions is met:
S The transmission is in neutral (the neutral
switch is closed).
S The clutch lever is pulled to the handlebar
(the clutch switch is closed) and the side-
stand is up (the sidestand switch is closed).
The starting circuit cut-off relay prevents the
starter motor from operating when neither of
these conditions has been met. In this instance,
the starting circuit cut-off relay is open so cur-
rent cannot reach the starter motor. When at
least one of the above conditions has been met
the starting circuit cut-off relay is closed and the
engine can be started by pressing the starter
switch.
1 Battery
2 Main fuse
3 Main switch
4 Ignition fuse
5 Engine stop switch
6 Starting circuit cut-off relay
7 Diode (starting circuit cut-off relay)
8 Clutch switch
9 Sidestand switch
10
Neutral switch
Start switch
11
12
Starter relay
Starter motor
13
Diode (starting circuit cut-off relay)
14
–5–
ELEC
WHEN THE TRANSMISSION IS IN
NEUTRAL
WHEN THE SIDESTAND IS UP AND
THE CLUTCH LEVER IS PULLED TO
THE HANDLEBAR
" and the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
