Table of Contents
Advertisement
6. PREPARATION BEFORE SEWING
6. PREPARATION BEFORE SEWING
6-1. Installing the needle
Turn off the power switch before installing the needle.
The motor will keep turning even after the power is switched off as a result of the motor's inertia. Wait until the
motor stops fully before starting work.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
3848M
6-2. Removing the bobbin case
Turn off the power switch before removing the bobbin case.
The motor will keep turning even after the power is switched off as a result of the motor's inertia. Wait until the
motor stops fully before starting work.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
2119M
9
CAUTION
Front
Long
groove
0795M
CAUTION
2120M
For thick materials
0798M
1. Turn the machine pulley to move the needle bar (1) to its
highest position.
2. Loosen the screw (2).
3. Insert the needle (3) in a straight line as far as it will go,
making sure that the long groove on the needle is at the
left, and then securely tighten the screw (2).
1. Turn the machine pulley to raise the needle until it is
above the needle plate.
2. Pull the latch (1) of the bobbin case upward and then
remove the bobbin case.
3. The bobbin (2) will come out when the latch (1) is
released.
S-1110A
Hide quick links:
Advertisement
Table of Contents
