IMPORTANT NOTICE This manual has been provided for the use of authorized Yamaha Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifically Yamaha Products, are already known and understood by the users, and have therefore not been restated.
XP1000/XP2500/XP3500 SPECIFICATIONS XP3500 100 V (J) 120 V (U,T) 230 V (H,B,K,O) 240 V (A) 8 Ω/STEREO Output Power 1 kHz 390 W+390 W 390 W+390 W 390 W+390 W 390 W+390 W THD+N= 1 % 4 Ω/STEREO 590 W+590 W...
To replace these circuit boards, take out the corresponding ones from the following sets of circuit board. For XP3500: IO35 set of circuit boards (WF399800) For XP2500: IO25 set of circuit boards (WF399900) For XP1000: IO10 set of circuit boards (WF400000)
Page 11
For XP3500: IO35 set of circuit boards (WF399800) For XP2500: IO25 set of circuit boards (WF399900) For XP1000: IO10 set of circuit boards (WF400000) [100] Top View IO3/4 IO4/4...
Page 13
XP1000/XP2500/XP3500 VR Circuit Board (Time Required: about 4 min) 7-1. 7-1 Remove the top cover. (See procedure 1.) 7-2. 7-2 Remove the front panel assembly. (See procedure 6.) 7-3. 7-3 Remove the two (2) attenuation knobs and the two (2) hexagonal nuts marked [D]. The VR circuit board can then be removed.
XP1000/XP2500/XP3500 10. PSW Circuit Board (Time Required: about 6 min) 10-1 Remove the top cover. (See procedure 1.) 10-1. 10-2 Remove the front panel assembly. (See procedure 6.) 10-2. 10-3 Remove the four (4) screws marked [420]. The handles 10-3. [420] and the handle angles in left and right can then be removed.
Page 15
FET and pair transistor marked [P70] (26 [P70] screws for XP1000, 30 screws for XP2500, 36 screws for XP3500). The PAL circuit board can then be removed. (Fig. 2, 6) [40] [40]: Bind Head Tapping Screw-B 4.0x8 MFZN2B3 (WE962000)
XP1000/XP2500/XP3500 CIRCUIT BOARDS SUB (IO 1/4) Circuit Board GAIN MODE +4dBu/26dB/32dB STEREO/BRIDGE/PARALLEL OFF/20Hz/55Hz OFF/20Hz/55Hz to VR-CN303 to DC-CN501 to IO3/4-W301B Components side INPUT B INPUT A SUB (IO 2/4) Circuit Board INPUT Components side ( Pattern side ( Pattern side...
Page 18
XP1000/XP2500/XP3500 DC Circuit Board to IO3/4-CN304 to IO3/4-W305 to PAL-CN103 to Power Transformer to PAL-CN102 to PAL-CN104 to PAL-CN101 SUB (VR) Circuit Board A’ Volume Control Volume Control Components side DC: 2NA-WF39790-D010 to IO1/4-CN301 SUB (VR): 2NA-WF39910-D010...
Page 19
XP1000/XP2500/XP3500 to AC IN to Power Transformer Components side ( A’...
Page 20
XP1000/XP2500/XP3500 DC Circuit Board B’...
Page 22
XP1000/XP2500/XP3500 PAL Circuit Board to DC-W401 to DC-W402 to DC-W403 C’ D’...
Page 23
XP1000/XP2500/XP3500 to IO3/4-W306 Components side ( C’ Pattern side ( D’ PAL: 2NA-WF39680-D010...
Page 24
XP1000/XP2500/XP3500 SUB (IO 4/4) Circuit Board SUB (LED) Circuit Board SPEAKERS SPEAKERS PROTECTION BRIDE POWER/STANDBY TEMP Components side ( SUB (PSW) Circuit Board to DC-CN416 ON/OFF to DC-CN402 to DC-CN401 to DC-CN403 Components side ( SIGNAL A CLIP A SUB (IO 3/4) Circuit Board...
Page 25
XP1000/XP2500/XP3500 SUB (LED) Circuit Board SUB (IO 4/4) Circuit Board Pattern side ( SUB (PSW) Circuit Board Pattern side ( SUB (IO 3/4) Circuit Board Pattern side ( Pattern side (...
Page 26
XP1000/XP2500/XP3500 INSPECTION Scope This inspection specifications is applied to the power amplifier XP1000/XP2500/XP3500. Power Source/Frequency Destination Voltage Frequency U, T 120 V 60 Hz H, B, K, O 230 V 50 Hz 240 V 50 Hz Preparation for STEREO/PARALLEL mode Attenuator "0"(MAX) (Both Channel)
Page 27
XP1000/XP2500/XP3500 3. 6 Frequency response Input signals are each 20Hz, 1kHz and 20kHz, -10dBu. The output voltage shall be -0.5 +/- 0.5dB at 20Hz and 20kHz compared to the 1kHz. Set HPF switch to 20Hz. With 20Hz -10dBu input signal, output voltage shall be -3.0 +/- 2.0dB compared to the value with 1kHz -10 dBu input signal at HPF switch OFF.
Page 28
XP1000/XP2500/XP3500 3.11 Protection circuit for DC fault Disconnect of load resistor from output terminal. PROTECTION LED shall light up within 2 seconds when short circuit on the two jumper wires that mounted of PCB ASSY DC circuit marked "DC-C". The LED shall light off within 10 seconds after getting the short off.
Page 29
XP1000/XP2500/XP3500 3.15.4 Model ID When the SW3 is turned on, the DC output voltage of 3pin of JK304 shall be within the range specified in the "ID-V" of following table. XP1000 XP2500 XP3500 ID-V 2.97 2.73 2.50 +/- 0.06 V +/- 0.06 V...
Page 30
XP1000/XP2500/XP3500 XP1000/XP2500/XP3500 100 V 50 Hz Attenuator "0"(MAX) (Both Channel) Input terminal cannon type connector: 2PIN-HOT/3PIN-COLD/1PIN-GND MODE switch STEREO GAIN switch 32dB HPF switch OFF (Both Cannel) Load resistor +/- 1% POWER LED PROTECTION LED PROTECTION LED "FAN-C" "TM-C" TEMP LED...
Page 33
XP1000/XP2500/XP3500 SW3 ON JK304 3 ID-V XP1000 XP2500 XP3500 ID-V 2.97 2.73 2.50 +/- 0.06 V +/- 0.06 V +/- 0.06 V SW4 ON POWER LED Attenuator "0"(MAX) Effective only channel A. Input terminal Cannon type connector: 2PIN-HOT/3PIN-COLD/1PIN-GND MODE switch...
Page 37
XP1000/XP2500/XP3500 DC 1/2, PSW CIRCUIT BOARD DC1/2 (XP1000/XP2500/XP3500) to PAL to FAN to IO 3/4 to DC 005:J3 to DC 005:J3 to DC 005:J3 REGULATOR +15 to DC 005:U10 to DC 005:U10 REGULATOR -15 from DC 005:U8 from DC 005:I6...
Page 38
XP1000/XP2500/XP3500 DC 2/2 CIRCUIT BOARD DC2/2 (XP1000/XP2500/XP3500) not installed to DC 004:J16 from DC 004:J4 from DC 004:J4 from DC 004:J4 to DC 004:C10 to IO(1/4) -CN302 to DC 004:C14 to DC 004:C14 to DC 004:C15 not installed to DC 004:C15...
Page 39
XP1000/XP2500/XP3500 SUB CIRCUIT BOARD SUB (XP1000/XP2500/XP3500) (1/4) INPUT CH A OP AMP (2/4) CH A INPUT CH B INPUT CH B (3/4) (4/4) OUT A OUTPUT CH A-2 to PAL-CN105 to DC-CN416 OUTPUT to DC-CN412 CH A-1 OUTPUT OUT B...
Page 40
XP1000/XP2500/XP3500 PAL CIRCUIT BOARD PAL (XP1000/XP2500/XP3500) to DC-W401 to DC-W402 to DC-W403 to DC-CN414 28CC1-2000007700 to IO3/4-W304 to IO3/4-W306 PAL CIRCUIT BOARD PAL (XP1000/XP2500/XP3500)
POWER AMPLIFIER PARTS LIST CONTENTS OVERALL ASSEMBLY ELECTRICAL PARTS 7-17 Notes: DESTINATION ABBREVIATIONS A: Australian model M: South African model B: British model O: Chinese model C: Canadian model Q: South-east Asia model D: German model T: Taiwan model E: European model U: U.S.A.