Cisco 501G Administration Manual page 125
Hide thumbs
Also See for 501G:
- User manual (93 pages) ,
- Administration manual (311 pages) ,
- Configuration manual (12 pages)
Table of Contents
Advertisement
Configuring Security, Quality, and Network Features
Configuring VLAN Settings
STEP 4
STEP 5
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
Enter the following parameters:
Parameter
Enable VLAN
Enable CDP
VLAN ID
Enable PC Port VLAN Tagging
PC Port VLAN Highest Priority
PC Port VLAN ID
Click Submit All Changes.
Description
Choose Yes to enable VLAN. Choose no to
disable.
Enable CDP
only if you are using a switch that
has Cisco Discovery Protocol. CDP is
negotiation based and determines which VLAN
the IP phone resides in.
If you use a VLAN without CDP (VLAN enabled
and CDP disabled), enter a
phone. Note that only voice packets are tagged
with the VLAN ID.
Enables VLAN and priority tagging on the phone
data port (802. 1 p/q). This feature facilities
tagging of the VLAN ID (802. 1 Q) and priority bits
(802. 1 p) of the traffic coming from the PC port of
the IP phone.
Defaults to No. Choose Yes to enable the
tagging algorithm.
0-7 (default 0). The priority applied to all frames,
tagged and untagged. The phone modifies the
frame priority only if the incoming frame priority
is higher than this value.
0-4095 (default 0). Value of the VLAN ID. The
phone tags all the untagged frames coming from
the PC (it will not tag frames with an existing
tag).
5
VLAN ID
for the IP
114
Hide quick links:
Advertisement
Chapters
Table of Contents
