Table of Contents
Advertisement
AUTO SETUP (InlelliBeam)
The supplied IntelliBeam microphone collects and analyzes the sound that this unit produces in your actual listening
environment. Follow the procedure below to connect the IntelliBeam microphone to this unit and make sure that the
IntelliBeam microphone is placed in a proper location and that there are no large obstacles between the IntelliBeam
microphone and the walls in your listening room.
• After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone.
• The IntelliBeam microphone is sensitive to heat.
- Keep it away from direct sunlight.
- Do
not place it on top of this unit.
• Do not connect the IntelliBeam microphone to an extension cable as doing so may result in an inaccurate sound optimization.
• An error may occur during the AUTO SETUP procedure if the IntelliBeam microphone is not properly placed in your listening room.
To avoid the possibility of an error:
- Do not place the IntelliBeam microphone to the extreme right or left from the center of this unit.
- Do not place the IntelliBeam microphone within 1.8 m (6.0 ft) from the front of this unit.
- Do not place the IntelliBeam microphone more than I m (3.3 ft) upper or lower from the center height of this unit.
• Make sure that there are no obstacles between the IntelliBeam microphone and the walls in your listening room as these objects
obstruct the path of sound beams. However, any objects that are in contact with the walls will be regarded as a protruding part of the
walls.
• The best possible results are achieved if the IntelliBeam microphone is placed at the same height as your ears would be when you are
seated in your listening position. However, if this is not possible, you can manually fine-tune the sound beam angle and balance the
sound beam output levels using MANUAL SETUP (see page 74) once the AUTO SETUP procedure is completed.
• If a subwoofer with adjustable volume and crossoverlhigh-cut frequency controls is connected to
IIOl.lJIIIE
CflOSSOYER
~
HtGHCUT
this unit, set the volume between 10 and 12 o'clock as viewed on a conventional clockface and set
~
tho
,,,,,,ovo,lhigb.,",
freq","y '" tho
m"imum.
0
0
_
IIAX
MI N MAX/
Subwoofer
Press STANDBY/ON to turn off the power of
this unit.
1
STANDBYIO~
Front panel
or
STANDBY/ON
~
Remote control
3
Place the IntelliBeam microphone on a flat
level surface more than 1.8 m (6.0
ft)
from the
front of the unit and within 1 m (3.3
ft)
upper
or lower from the center height of the unit
with the IntelliBeam microphone facing
upward at your normal listening position.
2
Connect the supplied IntelliBeam
microphone to the INTELLIBEAM MIC jack on
the front panel.
30
En
Be sure to place the IntelliBeam microphone on an
imaginary center line drawn from this unit.
You may want to use the supplied cardboard microphone
stand to affix the IntelliBeam microphone at the same height
as your ears would be when you are seated in your listening
position.
Advertisement
Table of Contents
