Table of Contents
Advertisement
After removing all the
packaging, carefully
lay machine on it's
back to remove the
polystyrene base from
the bottom.
Unscrew the three
bolts.
Open the porthole
and remove the poly-
styrene block fitted on
the door seal and all
objects inside the
drum.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
26
Remove the power
supply cable and the
drain hose from the
hose holders on the
rear of the appliance.
Slide out the relevant
plastic spacers.
Fill the smaller upper
hole and the two
large ones with the
corresponding plastic
plug caps supplied in
the bag containing
the instruction book-
let.
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materi-
als under the machine to compensate for any
unevenness in the floor.
Water inlet
Caution!
• This appliance must be connected to a
cold water supply
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
If necessary, check
the setting with a spi-
rit level.
www.zanussi.com
Hide quick links:
Advertisement
Table of Contents
