Table of Contents
Advertisement
INSP
STEERING A D J U S T M E N T / B A T T E R Y
2. Check:
=Steering assembly bearings
Grasp the bottom of the forks and gently
rock the rock assembly back and forth.
Looseness-*Adjust.
Steering head adjustment steps:
=Remove the front fender and front panel.
Refer to "FRONT FENDER, FRONT PANEL
AND FOOTREST BOARD" section.
=Tighten the ring nut ~ to specification us-
ing the Ring Nut Wrench (YU-33975).
Ring Nut (~:
30 Nm (3.0 m okg, 22 ftolb)
NOTE:
Set the torque wrench to the ring nut wrench
so that they form right angle.
*Move the handlebar up and down, and/or
back and forth. If handlebar free play is ex-
cess, tighten the bolt ( ~ to specification.
Bolt (~:
60 Nm (6.0 m-kg, 43 ft-lb)
=Install the front fender and front panel.
ELECTRICAL
BATTERY
1. Check:
= Fluid level
Incorrect-* Refill.
Fluid level should be between upper and
lower level marks.
(~ Upper level
(~) Lower level
iiii!!ii i ii i iiiii!iii!!i
Refill with distilled water only; tap water
contains minerals harmful to a battery.
2-21
- Quick Links:
- General Information
- Scooter Identification
Hide quick links:
Advertisement
Chapters
Table of Contents
