Power Dc Input - Cisco Catalyst 4500 Series Command Reference Manual
Cisco ios command reference
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
power dc input
power dc input
To configure the power DC input parameters on the switch, use the power dc input command. To return
to the default power settings, use the no form of this command.
Syntax Description
watts
Defaults
DC power input is 2500 W.
Command Modes
Global configuration mode
Command History
Release
12.1(11)EW
12.1(13)EW
Usage Guidelines
If your interface is not capable of supporting Power over Ethernet, you will receive this message:
Power over Ethernet not supported on interface Admin
Examples
This example shows how to set the total capacity of the external DC power source to 5000 W:
Switch(config)# power dc input 5000
Switch(config)#
Related Commands
Command
show power
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-510
power dc input watts
no power dc input
Sets the total capacity of the external DC source in watts; valid values are from
300 to 8500.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for dc input was added.
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays information about the power status.
OL-25342 -01
Advertisement
Chapters
Table of Contents
