Dynamic (Cable) - D-Link DIR-100 User Manual
Ethernet broadband router
Hide thumbs
Also See for DIR-100:
- Quick install manual (96 pages) ,
- User manual (70 pages) ,
- Quick installation manual (63 pages)
Table of Contents
Advertisement
Section 3 - Configuration
Dynamic IP
Choose Dynamic IP Address to obtain IP Address information
Address:
automatically from your ISP. Select this option if your ISP does
not give you any IP numbers to use. This option is commonly
used for Cable modem services.
Host Name:
The Host Name is optional but may be required by some ISPs.
The default host name is the device name of the Router and
may be changed.
MAC Address:
The default MAC Address is set to the WAN's physical interface
MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by
your ISP.
The default MAC address is set to the WAN's physical interface
Clone MAC
MAC address on the Broadband Router. You can use the "Clone
Address:
MAC Address" button to copy the MAC address of the Ethernet
Card installed by your ISP and replace the WAN MAC address
with the MAC address of the router. It is not recommended
that you change the default MAC address unless required by
your ISP.
Primary DNS
Enter the Primary DNS (Domain Name Server) server IP address
Addresses:
assigned by your ISP.
Secondary DNS
This is optional.
Address:
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1500 is the default
MTU.
D-Link DIR-100 User Manual
Internet Setup
Dynamic (Cable)
19
Advertisement
Table of Contents
