Table of Contents
Advertisement
4. Insert the dipstick into the filler hole (without
screwing it in), and then remove it again to
check the oil level.
1. Maximum level mark
2. Minimum level mark
TIP
The engine oil should be between the minimum
and maximum level marks.
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
NOTICE: Be sure the engine oil is at the
correct level, otherwise engine damage
6. Insert the dipstick into the oil filler hole, and
To change the engine oil
1
1. Place the ATV on a level surface.
2. Start the engine, warm it up for several min-
2
3. Place an oil pan under the engine to collect
4. Remove the engine oil filler cap, and then re-
8-11
may result.
[ECB00851]
then tighten the engine oil filler cap.
utes, and then turn it off.
the used oil.
move the engine oil drain bolt to drain the oil
from the crankcase. NOTICE: When remov-
ing the engine oil drain bolt, the compres-
sion spring, oil strainer and O-ring will fall
out.
Take
care
not
parts.
[ECB00311]
1
2
3
4
5
6
7
to
lose
these
8
9
10
11
Advertisement
Table of Contents
Troubleshooting
