Table of Contents
Advertisement
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
operate the socket spanner when loosening or tightening
the nut.
Fitting the trimmer guard and
trimmer head Trimmy SII
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hang the trimmer guard/combination
guard (A) on the two hooks on the plate holder (M).
Bend the guard around the shaft and tighten it with the
bolt (L) on the opposite side of the shaft. Use the
locking pin (C). Place the locking pin in the groove on
the screw head and tighten. See diagram.
M
A
•
Fit the drive disc (B) on the output shaft.
H
P
B
C
•
Centre the metal cup (P) on the drive disc's blade
guide.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
18 – English
ASSEMBLY
L
C
•
Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
H
C
•
Tighten the trimmer head to a torque of 35-50 Nm
(3.5-5 kpm).
•
To dismantle, follow the instructions in the reverse
order.
Fitting other guards and cutting
attachments
•
Fit the trimmer guard/combination guard (A) intended
for use with the trimmer head/plastic blades. Hang the
trimmer guard/combination guard (A) on the two
hooks on the plate holder (M). Bend the guard around
the shaft and tighten it with the bolt (L) on the opposite
side of the shaft. Use the locking pin (C). Place the
locking pin in the groove on the screw head and
tighten. See diagram.
M
A
•
Fit the drive disc (B) on the output shaft.
H
P
B
C
•
Centre the metal cup (P) on the drive disc's blade
guide.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
L
C
Advertisement
Table of Contents
