hit counter script

Removing And Replacing The Chassis Fan Assembly; Required Tools; Removing The Fan Assembly - Cisco Catalyst 4500e Series Installation Manual

Catalyst 4500 e-series switches
Hide thumbs Also See for Catalyst 4500e Series:
Table of Contents

Advertisement

Chapter 4
Removing and Replacing FRUs
In a system with multiple power supplies or a single triple-input power supply, connect each power
Caution
supply to a separate DC power source. In the event of a power source failure, if the second source is still
available, it can maintain maximum overcurrent protection for each power connection.
Verify power supply operation by checking the power supply's front-panel LEDs. You should see the
Step 8
following:
Check the power supply and system status from the system console by entering the show power
Step 9
command. For more information on the commands, refer to the command reference publication for your
switch and software.
If the LEDs or the show power command (Cisco IOS) output indicate a power problem or other system
Step 10
problem, see

Removing and Replacing the Chassis Fan Assembly

This section describes how to remove and install the chassis fan assembly for the Catalyst 4500 E-series
switches. See
very similar way.

Required Tools

You will need a Phillips screwdriver for the following two procedures.

Removing the Fan Assembly

Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray. Statement 258
Never operate the system for an extended period if the fan assembly is removed or if it is not functioning
Caution
properly. An over-temperature condition can cause severe equipment damage.
Follow these steps to remove the existing chassis fan assembly:
Loosen the two captive installation screws on the fan assembly by turning them counterclockwise.
Step 1
OL-13972-01
The LED labeled INPUT OK is green.
The LED labeled OUTPUT FAIL is not lit.
Chapter 5, "Troubleshooting,"
Figure 4-17
for the Catalyst 4506-E system fan assembly, other fan assemblies attach in a
Removing and Replacing the Chassis Fan Assembly
for more information.
Catalyst 4500 E-Series Switches Installation Guide
4-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents