Table of Contents
Advertisement
Contacting the Cisco Technical Assistance Center
Step 7
If you cannot connect to the switch through the me1 interface, make sure the connected device is
configured for half-duplex 10-Mbps operation.
Step 8
If the host is in the same subnet as the switch interface, make sure the switch interface and the switch
port to which the host is connected are assigned to the same VLAN (use the show interface and show
port commands to check).
If the host is in a different subnet, make sure the default gateway (default route) on the switch is
Step 9
configured with the address of a router in the same subnet as the switch interface (use the show ip route
command).
Check the status of the port connection—should be "connected" (use the show port command).
Step 10
Check the spanning-tree state on the port (use the show spantree mod_num/port_num command)—if the
Step 11
port is in listening or learning mode, wait until the port is in forwarding mode and try to connect to the
host again.
Make sure the speed and duplex settings on the host and the appropriate switch ports are correct (use the
Step 12
show port command).
If the connected device is an end station:
Step 13
a.
b.
c.
Make sure the switch is learning the MAC address of the host (use the show cam dynamic command).
Step 14
Step 15
If possible, try connecting to another port.
Cannot autonegotiate the port speed/duplex
Make sure autonegotiation is configured on both ends of the link (use the show port command)—you
cannot configure settings manually on one end of the link and configure the other end of the link for
autonegotiation. If autonegotiation fails when you connect a client NIC to the switch, check the NIC and
drivers to make sure that autonegotiation is supported.
If autonegotiation is supported and properly configured but you still cannot connect, turn off
autonegotiation and set the speed and duplex manually (use the set port speed and set port duplex
commands).
Contacting the Cisco Technical Assistance Center
If you are unable to solve a startup problem after using the troubleshooting suggestions in this chapter,
contact a Cisco TAC representative for assistance and further instructions.
Before you call, have the following information ready to help the Cisco TAC assist you as quickly as
possible:
•
•
•
Catalyst 4500 E-Series Switches Installation Guide
5-18
Enable spanning-tree PortFast on the port (use the set spantree portfast enable
command)—PortFast places the port in forwarding mode immediately, bypassing listening and
learning modes (do not use this feature for connections to non-end station devices).
Disable trunking on the port (use the set trunk mod_num/port_num off command).
Disable channeling on the port (use the set port channel port_list off command)—you must specify
a valid port range with this command—you cannot specify a single port.
Date you received the switch
Chassis serial number (refer to
Type of software and release number
Figure 5-3
for serial number locations)
Chapter 5
Troubleshooting
OL-13972-01
- Quick Links:
- Reset Button
- Power Supplies
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
