Table of Contents
Advertisement
1-10. Ejecting the Cassette Tape
Manually
n
Be sure to turn off the power, then pull out the power cord
and/or battery before performing the following procedure.
If not, damage to internal circuit may result.
1. Open the cover of the outside panel shown in the
figure.
2. Turn the gear clockwise while pushing a gear down-
ward until the front lid opens using a Philips screw-
driver. Then confirm that the tape is taken up the
cassette reel.
3. The front lid opens. The cassette tape can then be
ejected.
Front lid
DNW-7/90/90WS
2
1
Cover
Turn while pushing
(clockwise)
1-10. Ejecting the Cassette Tape Manually
m
Never turn the gear no further after the front lid
.
opened.
If the gear is turned moreover, gear phase will be out of
order, and then the opeation timing of the cleaning roller
will be shifted.
When performing the phase adjustment of the gear, refer
to section 3-3-4. Timing Belt (Threading) Replacement
of maintenance manual part2 volume1.
. Closing the front lid
In the state mentioned above, the front lid cannot be
closed and locked. Turn on the power, then close the
front lid.
If the above operation cannot be executed,
perform the following procedures.
1. Remove the front lid and outside panel.
(Refer to section 1-6.)
2. Put the cassette compartment into the cassette-up state
with the cassette lid of the cassette tape raised.
(For more details, refer to section 1-7.)
3. Remove the cassette tape taking care that the tape does
not get damage.
1-25
- Quick Links:
- Setup Menu
- Signal Input and Output
Hide quick links:
Advertisement
Table of Contents
