Show Interfaces Transceivers - Cisco Catalyst 3750-X Command Reference Manual
Cisco ios release 15.2(1)e and later
Hide thumbs
Also See for Catalyst 3750-X:
- Software configuration manual (1438 pages) ,
- Message manual (150 pages) ,
- Getting started manual (22 pages)
Table of Contents
Advertisement
show interfaces transceivers
show interfaces transceivers
Use the show interfaces transceivers privileged EXEC command to display the physical properties of
a small form-factor pluggable (SFP) module interface.
Syntax Description
interface-id
detail
dom-supported-list
module number
properties
threshold-table
Command Modes
User EXEC
Command History
Release
12.2(53)SE2
Examples
This is an example of output from the show interfaces interface-id transceiver properties command:
Switch# show interfaces gigabitethernet1/0/1 transceiver properties
Name : Gi1/0/1
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
This is an example of output from the show interfaces interface-id transceiver detail command:
Switch# show interfaces gigabitethernet1/0/3 transceiver detail
ITU Channel not available (Wavelength not available),
Transceiver is externally calibrated.
mA:milliamperes, dBm:decibels (milliwatts), N/A:not applicable.
++:high alarm, +:high warning, -:low warning, -- :low alarm.
A2D readouts (if they differ), are reported in parentheses.
The threshold values are uncalibrated.
Port
Catalyst 3750-X and 3560-X Switch Command Reference
2-662
show interfaces [interface-id] transceiver [detail | dom-supported-list | module number |
properties | threshold-table]
(Optional) Display configuration and status for a specified physical
interface.
(Optional) Display calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
(Optional) List all supported DoM transceivers.
(Optional) Limit display to interfaces on module on the switch. The range
is 1 to 9. This option is not available if you entered a specific interface ID.
(Optional) Display speed, duplex, and inline power settings on an interface.
(Optional) Display alarm and warning threshold table
Modification
This command was introduced.
Temperature
(Celsius)
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
High Alarm
High Warn
Threshold
Threshold
(Celsius)
(Celsius)
Low Warn
Low Alarm
Threshold
Threshold
(Celsius)
(Celsius)
OL-29704-01
Advertisement
Table of Contents
