Cluster Standby-Group - Cisco Catalyst 3750 Command Reference Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3750 Switch Cisco IOS Commands
cluster standby-group
Use the cluster standby-group global configuration command to enable cluster command-switch
redundancy by binding the cluster to an existing Hot Standby Router Protocol (HSRP). Entering the
routing-redundancy keyword enables the same HSRP group to be used for cluster command-switch
redundancy and routing redundancy. Use the no form of this command to return to the default setting.
Syntax Description
HSRP-group-name
routing-redundancy
Defaults
The cluster is not bound to any HSRP group.
Command Modes
Global configuration
Command History
Release
12.1(11)AX
Usage Guidelines
Enter this command only on the cluster command switch. If you enter it on a cluster member switch, an
error message appears.
The cluster command switch propagates the cluster-HSRP binding information to all cluster-HSRP
capable members. Each cluster member switch stores the binding information in its NVRAM. The HSRP
group name must be a valid standby group; otherwise, the command exits with an error.
The same group name should be used on all members of the HSRP standby group that is to be bound to
the cluster. The same HSRP group name should also be used on all cluster-HSRP capable members for
the HSRP group that is to be bound. (When not binding a cluster to an HSRP group, you can use different
names on the cluster commander and the members.)
Examples
This example shows how to bind the HSRP group named my_hsrp to the cluster. This command is
executed on the cluster command switch.
Switch(config)# cluster standby-group my_hsrp
This example shows how to use the same HSRP group named my_hsrp for routing redundancy and
cluster redundancy.
Switch(config)# cluster standby-group my_hsrp routing-redundancy
78-16181-03
cluster standby-group HSRP-group-name [routing-redundancy]
no cluster standby-group
Name of the HSRP group that is bound to the cluster. The group name is
limited to 32 characters.
(Optional) Enable the same HSRP standby group to be used for cluster
command-switch redundancy and routing redundancy.
Modification
This command was introduced.
cluster standby-group
Catalyst 3750 Switch Command Reference
2-67
Advertisement
Table of Contents
