WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Page 3
Installation During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit.
CONTENTS Installation Customer service Positioning What to do if the appliance is not functioning properly. Cleaning the interior Door reversibility Technical specification Electrical connection Control panel Operation-Temperature adjustment Fresh food refrigeration Movable wire shelves Use and features of the «CRISP’N FRESH» filter Cleaning the filter Positioning the door shelves Freezing of fresh food and storage of...
INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child.
Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations.
Door reversibility Fig. 2 Unplug the appliance from the power supply before carrying out the below-mentioned operations. Remove the ventilation grill (D). Unscrew the bottom hinge (E). Remove the freezer door by releasing it from the middle hinge (H). Unscrew the middle hinge. D640 Remove the fridge door by releasing it from the top hinge pin (A).
TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by 6% of the rated voltage.
Control panel A. Operating pilot light B. Thermostat knob Operation-Temperature adjustment Fresh food refrigeration Connect the plug to the wall socket. To obtain the best performance: Start by using a medium setting and then, later, select do not store warm food or evaporating liquids in the the thermostat position most suitable for your refrigerator;...
Movable wire shelves Fig. 6 ZFK 22/9 R The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D351 Fig. 6a ZFK 22/9 LR The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
Positioning the door shelves Fig. 9 To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
Freezing of fresh food and storage pictures of different types of food followed by a figure. These figures indicate the maximum storage of commercially frozen food time, in months, for each type of food. Details of food being stored, can also be written in The compartment marked by the symbol pencil on a card located in a special holder in the suitable for freezing food and for long term storage of...
Thawing Before being used, deep-frozen and frozen food can be thawed out either in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces of food – such as hamburgers, cutlets, chips, and fish fingers, for example – can be cooked straight from the freezer, without any intermediate thawing operation.
Page 14
The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
MAINTENANCE Interior light Unplug the appliance before carrying out any maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Warning - unscrew the light cover securing screw. This appliance contains hydrocarbons in its cooling - unhook the moving part as shown in the figure. unit;...