LAVADORA WASHING MACHINE FLS 1074 HC FLS 1021 HC Temp. Temp Taste Kochwäsche 60º- 95º Kurzprogramm 30º- 60º Buntwäsche 40º- 60º Spülen Buntwäsche 30º- 40º Weichspülen Pflegeleicht 30º- 60º Schleudern Wolle 30º- 40º Abpumpen Feinwäsche 30º- 40º F L S...
Page 2
Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
Contents Warnings Maintenance Bodywork Disposal Detergent dispenser drawer Drain filter Tips for environmental protection 25 Water inlet filter Emergency emptying out Technical specifications Frost precautions Installation Something not working? 40-41 Unpacking Positioning Water inlet Water drainage Electrical connection Your new washing machine Description of the appliance Detergent dispenser drawer Control panel...
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door •...
Child safety • Keep all detergents in a safe place out of children’s reach. • Children are often not aware of how dangerous • Make sure that children or pets do not climb into electrical appliances can be. When the machine is the drum.
Technical specifications DIMENSIONS Height 85 cm Width 60 cm Depth 58 cm MAXIMUM LOAD Cotton 4.5 kg Synthetics Delicates Woollens SPIN SPEED 1000 rpm max. POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W MINIMUM FUSE PROTECTION 10 A WATER PRESSURE Minimum 5 N/cm...
Installation Unpacking Positioning Install the machine on a flat hard floor. All transit bolts and packing must be removed Make sure that air circulation around the machine is before using the appliance. not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen You are advised to keep all transit devices so that units.
Water drainage Electrical connection The end of the drain hose can be positioned in three This machine is designed to operate on a 220-230 V, ways: single-phase, 50 Hz supply. Hooked over the edge of a sink using the plastic Check that your domestic electrical installation can hose guide supplied with the machine.
Your new washing machine This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. • The temperature selector dial will allow you to choose the most suitable temperature for your laundry. •...
Laundry weights Washing hints The following weights are indicative: Sorting the laundry bathrobe 1200 g napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens.
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly.
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not...
4. Select the temperature Operating sequence Turn the dial to the required setting. Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
7. At the end of the programme The machine stops automatically. If you have selected a programme which ends with the water of the last rinse left in the tub, drain the water before opening the door. Select programme “Q” (drain) or “P” (short spin). Wait one or two minutes before opening the door to give the electric locking mechanism time to release Depress the On/Off button again to switch the...
Programme table Washing programmes for cotton and linen Consumptions* Additional Programme Temp. Fabrics Max. load functions Energy Water Duration min. 60°-95° WHITES WITH 4.5 kg PREWASH, for example work garments, sheets, household linen, underwear, towels WHITES WITHOUT 60°-95° 4.5 kg PREWASH, for example household linen, sheets, shirts,...
Page 17
Programme table Washing programmes for synthetics, mixed fabrics, delicates and wool Consumptions* Additional Programme Temp. Fabrics Max. load functions Energy Water Duration min. 30°-60° SYNTHETICS 2 kg WITH PREWASH, underwear, coloured items, shirts, blouses 30°-60° SYNTHETICS 2 kg WITHOUT PREWASH, for example shirts, blouses, mixed fabrics...
Maintenance 1. Bodywork 3. Drain filter Clean the outside of the machine with warm water The drain filter collects threads and small objects and a neutral, non-abrasive household detergent. inadvertently left in the laundry. Check regularly that Rinse with clean water and dry with a soft cloth. the filter is clean.
5. Emergency emptying out If the water is not discharged (outlet pump is blocked, filter or drain hose are clogged), proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; •...
Something not working? Problems which you can resolve yourself. Problem Possible cause • The machine does not start up: • The door is not firmly closed. • The machine is not plugged in or there is no power at the socket. •...
Problem Possible cause • Spinning starts late or the • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in machine does not spin: the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.