IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information.
Disposal of old Appliances The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused...
OPERATION Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Setting the temperature The temperature inside the refrigerator is regulated by a thermostat with 6 temperature positions and one «OFF»...
Fresh food refrigeration Important To obtain the best performance, do not store warm Do not put carbonated liquids, (fizzy drinks etc.), in food or evaporating liquids in the refrigerator; do the freezer compartment. cover or wrap the food, particularly if it has a strong flavour.
Movable shelves The walls of the refrigerator have runners so that shelves can be positioned as desired. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram.
HINTS AND TIPS Normal Operating Sounds Energy Saving Advice • You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils • Do not install the appliance close to sources of or tubing at the rear, to the cooling heat, such as a boiler or radiator.
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Changing the light bulb out, DISCONNECT the appliance from the ELECTRICITY supply. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.
Page 9
Freezer When the frost has reached a thickness of up to 4mm it can be removed using the ice scraper provided with the appliance. During this operation it is not necessary to disconnect the appliance from the mains and remove the food. Never use metal tools for this operation.
SOMETHING NOT WORKING Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Symptom Solution No power to the appliance...
CUSTOMER CARE DEPARTMENT For general enquiries concerning your Zanussi-Electrolux appliance or for further information on Zanussi-Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi-electrolux.co.uk Customer Care Department...
We, Zanussi-Electrolux, undertake that if within 12 months of the date of the purchase this ZANUSSI-ELECTROLUX appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth 62.5 POWER SUPPLY VOLTAGE AND FREQUENCY 230-240 V / 50 Hz TOTAL POWER ABSORBED 120 W AVERAGE DAILY UNITS ELECTRICITY * 0,951 kWh GROSS CAPACITY Fridge 174 l Freezer 61 l NET CAPACITY Fridge 173 l Freezer 57 l...
INSTALLATION Please ensure that when the appliance is Important installed it is easily accessible for the engineer in the event of a breakdown. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be Important easily accessible after installation.
For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. Electrical connections The plug must not be used if the fuse cover/carrier is Any electrical work required to install this appliance lost. The cover/carrier is indicated by the coloured should be carried out by a qualified electrician or insert at the base of the plug.
Rear spacers The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance. Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the diagram.