Transmission Oil - Yamaha Grizzly YFM125GW Owner's Manual

Table of Contents

fall out. Take care not to lose these parts.

5. Clean the oil strainer with solvent.

6. Check the O-ring for damage and replace it if

necessary.

7. Install the O-ring, oil strainer, compression

spring and drain bolt. Tighten the engine oil

drain bolt to the specified torque.

ECB00320

CAUTION:

Before installing the engine oil drain bolt, be

sure to install the O-ring, compression spring

and oil strainer.

Tightening torque:

Engine oil drain bolt:

32 Nm (3.2 m·kgf, 23.1 ft·lbf)

8. Add the specified amount of the recommend-

ed engine oil, and then install and tighten the

engine oil filler cap.

Recommended oil:

See page 10-1.

Oil quantity:

1.25 L (1.32 US qt) (1.10 Imp.qt)

ECB00330

CAUTION:

Do not use oils with a diesel specification of

"CD" or oils of a higher quality than speci-

fied. In addition, do not use oils labeled "EN-

ERGY CONSERVING II" or higher.

Make sure that no foreign material enters the

crankcase.

9. Start the engine, and then let it idle for several

minutes while checking it for oil leakage. If oil

is leaking, immediately turn the engine off and

check for the cause.

10. Turn the engine off, and then check the oil lev-

el and correct it if necessary.

EBU27021