Table of Contents
Advertisement
1. Tilt support lever
EMU26400
Top cowling release lever
The top cowling can be removed by operat-
ing the cowling release lever. Pulling the
front lever unlocks the top cowling for remov-
al.
When installing the top cowling:
1.
Set the top cowling straight down onto
the engine, being careful to avoid catch-
ing spark plug wires or other wires.
2.
Align the three cowling hooks with the
locks on the bottom cowling.
3.
Press down on the top of the cowling at
the front and both sides of the back until
the three locks click.
1
ZMU03979
4.
ECM00070
CAUTION:
Make sure the cowling lock connection
G
cable is operating correctly before rein-
stalling the top cowling.
When the release lever is operated,
G
both the front and rear cowling hooks
should be released at the same time. If
not, adjust the rear clamp cable adjust-
ers.
Make sure the cable operates smoothly
G
and is free of corrosion.
Check that the cable is properly se-
G
cured in the holder.
ZMU03518
When reinstalling the cowling, ensure
G
that both the front and rear locks have
operated properly. If the cowling has
not been locked properly, some parts
may be damaged by the top cowling
shaking during operation.
EMU26460
Flushing device
This device is used to clean the cooling wa-
ter passages of the motor using a garden
hose and tap water.
NOTE:
For details on usage, see page 43.
Basic components
To make sure the cowling is locked
properly push the cowling from each
side. If it lifts, repeat step 3.
ZMU03519
16
Advertisement
Table of Contents
