Clamping The Outboard Motor - Yamaha F6B Ower's Manual
Outboard motor f6b; f8b; t8b
Hide thumbs
Also See for F6B:
- Owner's manual (244 pages) ,
- Owner's manual (206 pages) ,
- Owner's manual (242 pages)
Table of Contents
Advertisement
EMU01318¯
CLAMPING THE OUTBOARD MOTOR
1) Place the outboard on the transom so
that it is positioned as close to the cen-
ter as possible. Tighten the transom
clamp screws evenly and securely.
Check the clamp-screws for tightness
occasionally during operation of the
motor as they can work loose due to
engine vibration.
WARNING
@
Loose clamp screws could allow the
motor to move on the transom or fall off
the transom. This could cause loss of
control and serious injury. Make sure the
transom screws are tightened securely.
Occasionally check the screws for tight-
ness during operation.
@
2) An engine restraint cable or chain
should be used. Attach one end to the
engine restraint cable attachment point
and the other to a secure mounting point
on the boat. Otherwise, the engine could
be completely lost if it accidentally falls
off the transom.
Secure the clamp bracket to the transom
with the bolts provided with the out-
board. For details, consult your dealer.
WARNING
@
Avoid using bolts, nuts or washers other
than those contained in the engine pack-
aging. If used, they must be of at least
the same quality of material and strength
and must be tightened securely. After
tightening, test run the engine and check
their tightness.
@
1 Motor mounting parts
3-4
E
Hide quick links:
Advertisement
Chapters
Table of Contents
