Table of Contents
Advertisement
ESU12270
Adjusting the headlight beams
1.
Remove the top cover. (See page 42 for
removal procedures.)
2.
Use a Phillips screwdriver to turn the
headlight beam adjusting screw and ad-
just the headlight beams. To lower the
headlight beams, turn the headlight
beam adjusting screw in direction (a). To
raise the headlight beams, turn the head-
light beam adjusting screw in direction
(b).
1. Headlight beam adjusting screw
3.
Install the top cover.
ESU12290
Fittings and fasteners
Check the tightness of the fittings and fasten-
ers.
Tighten in proper sequence and torque if nec-
essary.
ESU12300
Battery
This snowmobile is equipped with a sealed-
type (MF) battery, which does not require any
maintenance. There is no need to check the
electrolyte or to add distilled water.
To charge the battery
Have a Yamaha dealer charge the battery as
soon as possible if it seems to have dis-
charged. Keep in mind that the battery tends
to discharge more quickly if the snowmobile is
equipped with electrical accessories.
Periodic maintenance
EWS00540
WARNING
Battery electrolyte is poisonous and dan-
gerous. It contains sulfuric acid and can
cause severe burns. Avoid contact with
skin, eyes, or clothing.
ANTIDOTE:
EXTERNAL: Flush with water.
G
INTERNAL: Drink large quantities of wa-
G
ter or milk. Follow with milk of magne-
sia, beaten egg, or vegetable oil. Call
physician immediately.
EYES: Flush with water for 15 minutes
G
and get prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flame, cigarettes, etc. away. Venti-
late when charging or using in an en-
closed space. Always shield your eyes
when working near batteries.
KEEP OUT OF THE REACH OF CHILDREN.
ESU12331
Replacing a fuse
EWS00550
WARNING
Be sure to use the specified fuse. A wrong
fuse could cause electrical system dam-
age or A FIRE HAZARD.
ECS00631
CAUTION:
Be sure to turn the main switch to the off
position and disconnect the negative bat-
tery lead to prevent accidental short-cir-
cuiting.
1.
Remove the shroud, the left and right
side covers, and the top cover. (See page
42 for removal procedures.)
2.
Remove the headlight unit bolts, discon-
nect the headlight couplers and speed-
ometer coupler, and then remove the
headlight unit.
67
Advertisement
Table of Contents
