Related Manuals for Haier 50FREE-1
Summary of Contents for Haier 50FREE-1
- Page 1 Fully Automatic Washing Machine This manual is for 50FREE-1 Please read this manual carefully before using. Retain it for future reference. Special number:0030805887A...
-
Page 2: Table Of Contents
CONTENTS Specification Names of the parts Safety precautions Installation and adjustment Install the water inlet hose Preparation before washing Put in the laundries Usage of the detergent Close the top lid Use the operation buttons Finish washing Disposal after washing Trouble-shooting answer to question Packing list Specification table... -
Page 3: Names Of The Parts
Packing list Quantity Water inlet hose The side of connection between the water inlet hose and the washing machine The side of connection between the jointer of the water inlet hose and the water faucet Bottom plate Inside in inner tub of washing machine Inner cover component Inside in inner tub of washing... -
Page 4: Safety Precautions
Safety precautions The washing machine must be positioned so that Please plug the power plug on special receptacle. the plug is accessible. Be sure to pull the plug off Be sure to use three-pins power receptacle. Ensure and close the water faucet in following cases: that the earthing prong of the power receptacle is power failure, delivering the machine, setting the earthed reliably. - Page 5 Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean the detergent box and set it on The lint filter must be used during washing.
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine. Install the inner cover 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. -
Page 7: How To Change The Direction Of The Drain Hose
Steps of using the operation buttons and description of the steps Soak Wash Spin Sterilize Rinse Thrice Twice Once Reserve Lock 1.Push "power" button to switch on the power 2.Push "program" button to select suitable full-auto program After the power is switched on, "standard" is automatically set. To select other full-auto program, please push the "program"... -
Page 8: Install The Water Inlet Hose
Install the water inlet hose 1. Attach the water inlet hoses to the water faucet. Using pliers, tighten the coupling. ( As figure 1) NOTE: Do not over tighten. Damage to the valves can result. 2. Connect the other ends to the water inlet valve . ( As figure 2) Jointer of the water inlet hose Jointer of the... - Page 9 Twice Once Take down the water inlet hose Lock 1.After using,Close the water tap. 2. Pull off the water inlet hose from the water tap and washer "Spin" button Push "spin" button to set spin procedure. In standard, carpeting programs, push the "spin"...
-
Page 10: Preparation Before Washing
For whitener in powder, dissolve it before use. 4. Close the top lid As the top lid opened,the washer will automaticlly givean alam and stop running,exclusively during draining The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time.