GE JGP329 Installation Instructions Manual page 11
30" sealed gas cooktop
Hide thumbs
Also See for JGP329:
- Owner's manual (36 pages) ,
- Installation instructions manual (33 pages) ,
- Installation instructions manual (32 pages)
Table of Contents
Advertisement
Installation
Instructions
[_]
CHECK IGNITERS
Operation
of the electric igniters should be checked
after the cooktop and supply line have been
carefully
checked for leaks and
the cooktop
has been connected
to the electrical
power.
On models so equipped,
check to be sure the
cooktop
is in the UNLOCKED position.
[]
Push and turn a burner valve to the LITE
position. All spark igniters will make a series of
sparks (ticking sounds), but only the burner
turned to LITE will light.
* The burner should light when gas is
available to the burner.
* Once the burner lights, it should be turned
out of the LITE position.
[]
Try each valve separately
until all burners
have been checked.
BURNER IGNITION
Cooktop Spark Ignition-When
you turn
the cooktop
knob to LITE, the spark igniter makes a
series of electric sparks (ticking sounds) which light
the burner. During a power failure, the burners will
not light automatically.
In an emergency,
a cooktop
burner may be lit with a match by following
the
steps below.
_WARNING:
Lighting gas burners with a
match is dangerous.
You should match light the
cooktop
burners only in
an emergency.
On models so equipped,
check to be sure the
cooktop
is in the UNLOCKED position.
rA1
Light a match and hold the flame near the
burner you want to light. Wooden
matches
work best.
rB1
Push in and turn the control knob slowly. Be
sure you are turning the correct
knob for the
burner you are lighting.
NOTE: If the burner does not light within five seconds,
turn the knob off and wait one minute before trying
again.
|
THE BURNER FLAMES
Turn each burner on. Flames should be blue in color
with no trace of yellow. The burner flames should
not flutter or blow away from the burner. The flame
should be no less than 1/4" on the lowest setting
and no greater than :1-1/2" on highest setting.
A!
J n^_L,iL,r.
fyou attempt tomeasure
the flame, please use caution.
Burns could result.
1/4"to
i-i/2"
Cooktop Burner
Burners should be checked frequently
r_
BURNER GRATES
The four cooktop
grates are designed for specific
positions. For maximum
stability, these grates
should only be used in their proper position: they
should not be interchanged.
For your convenience,
the undersides of the left and right grates are
marked "OUTSIDE" and "INSIDE". Make sure that the
side marked "OUTSIDE" is on the outer edge of your
cooktop.
"OUTSIDE ....
INSIDE....
OUTSIDE"
edge
edges
edge
11
Advertisement
Table of Contents
