Table of Contents
Advertisement
7.
Change the jumper (J11) setting as shown in figure below.
IMPORTANT:
its default position.
If the remote management card (option) is installed in your server, follow these steps to
configure the firmware program.
8.
Place the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the
server.
9.
Run "Initialize Remote Management Card".
Refer to Chapter 6 for details.
: Strap
Standard
Redundant
configuration
Mother board
To avoid system malfunction, leave other jumpers at
Upgrading Your Server 9-47
Advertisement
Table of Contents
Troubleshooting
