Resetting The Switch - Cisco Catalyst 3560-C Getting Started Manual
Hide thumbs
Also See for Catalyst 3560-C:
- Installation manual (37 pages) ,
- Hardware installation manual (92 pages)
Table of Contents
Advertisement
Catalyst 3560-C and 2960-C Switch Getting Started Guide
Resetting the Switch
Caution
OL-23802-02
Did you connect the Ethernet
cable to the console port instead
of to a 10/100/1000 Ethernet port
on the switch?
Did you wait 30 seconds after you
connected the switch and the PC
before you entered the IP address
in your browser?
Did you enter the wrong address
in the browser, or is there an error
message?
Follow these steps to return your switch to the factory default settings. These are
reasons why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to reset the password on the switch.
•
Resetting the switch reboots the switch.
If yes, disconnect the cable from the console
port. Then connect the cable to an Ethernet
port on the switch and on the PC. Wait 30
seconds before you enter 10.0.0.1 in the
browser.
The console port is outlined in blue,
Note
and the Ethernet port is outlined in
yellow.
If not, wait 30 seconds, re-enter 10.0.0.1 in
the browser, and press Enter.
If yes, re-enter 10.0.0.1 in the browser, and
press Enter.
Catalyst 3560-C and 2960-C Switch Getting Started Guide
21
Hide quick links:
Advertisement
Table of Contents
