Cisco Ubr10012 Router Configuration Tools - Cisco uBR10012 Software Configuration Manual
Universal broadband router
Hide thumbs
Also See for uBR10012:
- Hardware installation manual (280 pages) ,
- Troubleshooting manual (86 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Chapter 1
Overview of Cisco uBR10012 Universal Broadband Router Software
Cisco uBR10012 Router Configuration Tools
The Cisco uBR10012 Universal Broadband Router provides you with the following configuration tools,
allowing you flexibility in choosing your configuration method:
•
•
•
•
•
AutoInstall
The AutoInstall process configures the Cisco uBR10012 router automatically after connection to your
WAN. For additional information, refer to the
AutoInstall" section on page
Cable Interface Setup Facility
The Cisco uBR10012 router Setup facility (also called the System Configuration dialog) is a useful and
efficient tool for configuring your CMTS. The Setup facility supports the a number of functions so that
cable interfaces and cable interface line cards are fully operational (after initial setup). Refer to the
"Configuring the Cisco uBR10012 Router Using the Setup Facility" section on page
Configuration Mode (Command Line Interface Configuration)
The Configuration mode allows you to configure the Cisco uBR10012 router manually if you prefer not
to use Autoinstall or the Cable Interface Setup facility. For additional information, refer to the
"Configuring the Cisco uBR10012 Router Manually Using Configuration Mode" section on page
Cisco Network Registrar
Cisco provides the Cisco Network Registrar with each Cisco uBR10012 router.
Cisco Network Registrar dramatically improves the reliability of naming and addressing services for
enterprise and service provider networks. Cisco Network Registrar provides scalable Domain Name
System (DNS) and Dynamic Host Configuration Protocol (DHCP) services and forms the basis of a
DOCSIS CM provisioning system.
Cisco Network Registrar is a configuration tool that automates dynamic IP address allocation to
cable interfaces, PCs, and other devices on the broadband network. Cisco Network Registrar allows you
to track serial numbers and MAC addresses for each cable interface on your network, and reduces
customer service involvement when tracking subscriber CPE equipment.
For additional information about configuring or using Cisco Network Registrar, refer to the latest
Cisco Network Registrar documentation at the Cisco Web site (http://www.cisco.com). One such
document is
Cisco Subscriber Registration Center Device Provisioning Registrar
Extended Setup Facility
The Cable Interface Setup facility (described previously in this section) creates an initial CMTS
configuration. The Extended Setup facility prompts you to configure each interface on the system as you
progress through the CMTS configuration. For additional information, refer to the
Cable Interface with the Extended Setup Facility" section on page
OL-1520-05
AutoInstall
Cable Interface Setup Facility
Cisco Network Registrar
Configuration Mode (Command Line Interface Configuration)
Extended Setup Facility
2-7.
Installing the Cisco Network Registrar
Supported Software Features for the Cisco uBR10012 Router
"Configuring the Cisco uBR10012 Router Using
for the Cisco uBR7200 series routers, and the
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
2-8.
2.0, both located on Cisco.com.
"Configuring the
2-14.
2-13.
1-15
Advertisement
Chapters
Table of Contents
Troubleshooting
