Sony PMW-TD300 Supplement Manual page 6
Solid-state memory 3d camcorder
Hide thumbs
Also See for PMW-TD300:
- Operating instructions manual (185 pages) ,
- User manual (2 pages) ,
- Brochure & specs (8 pages)
Table of Contents
Advertisement
switch, the COLOR TEMP. button, and the
ASSIGNABLE 5 switch.
• REC START button: the VTR button on the
lens, and buttons and switches to which the
function has been assigned using OPERATION
>Assignable SW in the setup menu, including
the ASSIGN. 1/3 switches, the ASSIGNABLE
4 switch, the COLOR TEMP. button, and the
ASSIGNABLE 5 switch (when
MAINTENANCE >Camera Config >RM Rec
Start in the setup menu is set to [RM]).
To connect the monitor to the RM-B150/
B750
The MONITOR connector (BNC type) of the
RM-B150/B750 outputs a composite signal. To
connect a monitor to the MONITOR connector on
the RM-B150/B750, use the black cable supplied
with the RM-B150/B750.
To release Remote Control mode
Turn off the camcorder and disconnect the RM-
B150/B750.
The settings on the controls on the camcorder
become valid.
Camera image quality adjustment items
when the RM-B150/B750 is connected
When the RM-B150/B750 is connected, the
parameters for camera image quality adjustment
items (paint data) are reset to the parameters that
were specified the last time that RM-B150/B750
was connected.
Function of the recording start/stop
buttons when the RM-B150/B750 is
connected
When the RM-B150/B750 is connected, you can
make a setting to determine which of the
recording start/stop buttons you will use. This
setting is made using MAINTENANCE >Camera
Config >RM Rec Start in the setup menu.
6
Operating from the RM-B150/B750
Relationship between the setting of the RM Rec
Start item and the function of recording start/stop
buttons
Recording start/
Settings of RM Rec Start
stop button
RM
REC START button Disabled Enabled Enabled
VTR button
Disabled Enabled Enabled
Buttons and
Disabled Enabled Enabled
switches to which
the recording start/
stop function has
been assigned
(ASSIGN. 1/3
switches,
ASSIGNABLE 4
switch, COLOR
TEMP. button, and
ASSIGNABLE 5
switch)
Remote control
Enabled Disabled Enabled
unit's VTR button
Structure of the paint adjustment data
The non-volatile memory of the camcorder used
for storing paint adjustment data consists of two
regions as shown below: one is the "main data
block" that is used when a remote control unit is
not connected, and the other is the "remote
control data block" that is used when a remote
control unit is connected. Paint adjustment data is
automatically selected and output to the camera
section depending on whether or not a remote
control unit such as the RM-B150 is connected.
CAM
PARA
Advertisement
Table of Contents
