D-Link DCS-60 User Manual

User manual

Hide thumbs Also See for DCS-60:

Download this manual

Model No.: DCS-60

Ⅰ. Introduction

The DCS-60 Camera Housing is constructed from die-cast aluminium and is powder coated

and stove ﬁnished.The design and manufacture is to the highest technical standard with

environmental protection to level IP 67. The Housing is supplied complete with an adjustable

Fully-Cable-Managed Bracket (the concealed cable channel inside the mounting bracket).

Ⅱ. Mounting conﬁguration of DCS-60

Fig.1

Fig.2

Inner space for camera mount

W105 x H80 x L250mm

1. Use the rear section of the Mounting Bracket (D) as

a template for marking the position on the wall of the

Mounting Holes (H). Remove & drill to pattern required.

2. Attach the Mounting Bracket arm to the wall using the

rawlplugs and screws provided.

3. Feed cables from the main Housing (C) through the

hole of the Mounting Plate (E) on the Mounting Bracket

(D), and then feed the cable again to the concealed

channel inside the Mounting Bracket throughout the

wall outlet (A) or bracket outlet (B).

4. Attach the main Housing (C) to the Mounting Plate

(E) of the Bracket with 4 of 1/4" x 14.7 mm Trilobular

screws (F) provided.

5. Release Screw (G) on the Mounting Bracket to pan

and tilt the Housing . Position the Housing as required

for the correct Camera coverage, and then tighten both

screws to secure.

User's Manual

Page 1 Model No.: DCS-60 Ⅰ. Introduction The DCS-60 Camera Housing is constructed from die-cast aluminium and is powder coated and stove ﬁnished.The design and manufacture is to the highest technical standard with environmental protection to level IP 67. The Housing is supplied complete with an adjustable Fully-Cable-Managed Bracket (the concealed cable channel inside the mounting bracket).
Page 2 ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER AGAIN WHEN REASSEMBLING THE HOUSING. Fig.4 Wiring diagram of DCS-60 Ⅳ. Wiring diagram Fig.4 shows the internal wiring diagram of DCS-60 for the window demister.
Page 3 The customer's sole and exclusive remedy and the entire liability of D-Link and its suppliers under this Limited Warranty will be, at D-Link’s option, to repair or replace the defective Hardware during the Warranty Period at no charge to the original owner or to refund the actual purchase price paid.
Page 4 This Limited Warranty provides specific legal rights and you may also have other rights which vary from state to state. Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective owners.