Epson TM-T88III Programming Manual page 579

Paper roll printers esc/pos application

Hide thumbs Also See for TM-T88III:

Table of Contents

C O N F I D E N T I A L

• Initializing by turning on the power by switch.

• Initializing by hardware reset.

• Initializing by software reset, such as by transmitting Function 2.

• Initializing after the self test.

With a serial interface, when communication with the printer uses XON/XOFF control, the XOFF code may

interrupt the "Header to NUL" data string.

With a parallel interface, it is desirable for the host to be in a reverse idle state; however, because the host

computer cannot always be in the reverse idle state, it is necessary to enter reverse mode regularly to

watch for a notice.

[Explanation for memory switch 2] (

• Character code system is specified by [Msw2-3] (the third bit) as shown in the following table.:

[Model-dependent variations]

TM-J2000/J2100

Receive buffer capacity [Msw 1-2]: Large (when

This printer doesn't support [Msw 2-3] (Selecting character code system for the simplified Chinese

= 8, memory switch 8 is set as follows:

Setting value (

8-1 to 8-7 50

Setting the memory switch ([Msw 1-2] ~ [Msw 1-5], [Msw 1-7], [Msw 1-8], [Msw 2-2]) can be

changed by "Memory switch setting mode" by the panel switch operation when the power supply

is turned on.

Customize commands

Character code system Number of characters

TM-J2000/J2100, TM-T90, TM-L90,

Roll paper cover open during printing: automatic recoverable error

Roll paper cover open during printing: recoverable error

= 48) = 4 KB; small (when

= 49) = 45 bytes

Ver. 10.01 p. 579

Show Quick Links

Table of Contents