Epson TM-T88III Programming Manual page 191
Paper roll printers esc/pos application
Hide thumbs
Also See for TM-T88III:
- Specification (183 pages) ,
- User manual (65 pages) ,
- Technical bulletin (5 pages)
Table of Contents
Advertisement
C O N F I D E N T I A L
TM-J2000/J2100
The horizontal motion unit is specified by GS P.
See GS ( E Functions 5 for specifying the paper width.
TM-T90
The horizontal motion unit is specified by GS P.
See GS ( E Functions 5 and 6 for specifying the paper width.
TM-T88III
The horizontal motion unit is specified by GS P.
TM-L90
The horizontal motion unit is specified by GS P.
When a set value of the paper layout (horizontal size of the print area) is smaller than the print
area (initial value of this command), it is not possible to print in the area where the paper layout
(horizontal size of the print area) is exceeded.
See GS ( E Functions 5 for specifying the paper width.
See GS ( E Functions 49 and 50 for the paper layout (origin of layout, horizontal size of print area).
TM-L60II
The horizontal motion unit is specified by GS P.
The paper type, thermal paper or label paper, is selected by a DIP switch:
Serial interface model: DIP switch [SW2-6]
Parallel interface model: DIP switch [SW1-7]
TM-P60
The horizontal motion unit is approximately 0.125 mm {1/203 inches}. This value equals one dot
pitch.
See GS ( E Function 5 for specifying the paper width.
Paper roll
Print position commands
GS W
Ver. 10.01 p. 191
Hide quick links:
Advertisement
Table of Contents
