Table of Contents
Advertisement
Selector
No.
1
|
Not used.
7
Erasure of message stored in the
memory after the message
8
transfer
Selector 8:
Erasure of message
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
Selector
No.
1
ECM* in sending
2
ECM* in receiving
3
Call Waiting Caller ID
4
Not used.
5
Acceptable TCF bit error rate (%)
|
(Only at 4800 bps)
8
NOTE: Selector 3 is applicable to the American version only, but not applicable to those models
equipped with high-speed modem.
NOTE: Selectors 5 through 8 are applicable to the Asian version only.
Selector 3:
Call Waiting Caller ID
Setting this selector to "0" allows the user to decide whether or not to interrupt the current call when
a new call comes in. If Call Waiting Caller ID service is available in the area and the user
subscribes to it, he/she can see information about his/her incoming call.
Selectors 5 through 8:
Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you
set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.
WSW21 (TAD setting 1)
Function
WSW22 (ECM setting)
Function
Acceptable TCF bit error rate (%)
25
Setting and Specifications
0: Yes
1: No
Setting and Specifications
0: ON
1: OFF
0: ON
1: OFF
0: ON
1: OFF
0: 0%
1: 8%
0: 0%
1: 4%
0: 0%
1: 2%
0: 0%
1: 1%
* ECM: Error correction mode
Advertisement
Chapters
Table of Contents
Troubleshooting
