Paper Gap Adjustment - Epson Stylus 1000 Service Manual
Terminal printer
Hide thumbs
Also See for Stylus 1000:
- Specification sheet (1 page) ,
- Product information (13 pages) ,
- User manual (123 pages)
Table of Contents
Advertisement
Stylus-800/1000 SERVICE MANUAL
4.1 Adjustment
This addendum only explains the adjustment procedures which specifically applicable to the Stylus-1000.
4.1.1 Paper Gap Adjustment
Insert the plastic plate into a paper path from the rear of the printer, at the position shown in figure
[Step 1]
below.
[Step 2]
Put the thickness gauge (#F518 / t=l.Omrn) on the plastic plate and move the carriage onto it.
Certain thick and stiff paper can be used with this adjustment as a substitute for the plastic plate.
[Step 3]
Verify that a gap exist between the front edge of the carriage frame and the front frame. The
direction of carriage guide shaft holder rotation is depending on the existence of this gap, as shown
in table below.
I
(Gap exist between printhead and PG gauge)
Note) The direction in table above, is viewed from a side frame to which the corresponding
carriage guide shaft holder is attached.
Rotates BUSH, PARALLEL, ADJUST that attached at the left end of the carriage guide shaft as the
[Step 4]
gauge, the front edge of the carriage unit pop up and if so, moves the bush 1 step in reverse
direction.
[Step 5]
Remove the PG gauge and attach it at the right side adjust position.
[Step 6]
Repeat the step from [Step
the right end of the carriage guide shaft.
[Step n
move the left end bush 1 step in counter-clockwise (CCW).
REV.-A
Carriage and Front frame
YES
2] to [Step 4], and adjust the
I
Figure 4-1 Adjust Tool Set Position
LEFT Bush
gap with BUSH, PARALLEL, ADJUST at
I
I
I
!
ADDENDUM
Adjustment
RIGHT Bush
Cw
Cw
4 - 1
Advertisement
Table of Contents
